[PATCH v2 1/6] arm64: dts: qcom: sm8250-hdk: Enable the sdhc_2 port

[ShiTou Hong <redstone.dcity@gmail.com>]

The sm8250-hdk has an on-board SD/UFS card slot,
but the SDHCI port hasn't been enabled in the dts,
so we can't use it after booting.

Enable the dts node of SDHCI for the on-board SD card slot.
Add the pinctrl node of the SD card pins.

Co-developed-by: KancyJoe <kancy2333@outlook.com>
Signed-off-by: KancyJoe <kancy2333@outlook.com>
Signed-off-by: ShiTou Hong <dc_redstone@outlook.com>
---
 arch/arm64/boot/dts/qcom/sm8250-hdk.dts | 39 +++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sm8250-hdk.dts b/arch/arm64/boot/dts/qcom/sm8250-hdk.dts
index c1c673086..ad60be5d5 100644
--- a/arch/arm64/boot/dts/qcom/sm8250-hdk.dts
+++ b/arch/arm64/boot/dts/qcom/sm8250-hdk.dts
@@ -396,8 +396,47 @@ &qupv3_id_1 {
 	status = "okay";
 };
 
+&sdhc_2 {
+	cd-gpios = <&tlmm 77 GPIO_ACTIVE_LOW>;
+
+	vmmc-supply = <&vreg_l9c_2p96>;
+	vqmmc-supply = <&vreg_l6c_2p96>;
+
+	pinctrl-names = "default", "sleep";
+	pinctrl-0 = <&sdc2_default>, <&sd_ufs_cd_pins>;
+	pinctrl-1 = <&sdc2_sleep_state>, <&sd_ufs_cd_pins>;
+
+	status = "okay";
+};
+
 &tlmm {
 	gpio-reserved-ranges = <28 4>, <40 4>;
+
+	sd_ufs_cd_pins: sd-ufs-cd-default-state {
+		pins = "gpio77";
+		function = "gpio";
+		bias-pull-up;
+	};
+
+	sdc2_default: sdc2-default-state {
+		cmd-pins {
+			pins = "sdc2_cmd";
+			bias-pull-up;
+			drive-strength = <10>;
+		};
+
+		data-pins {
+			pins = "sdc2_data";
+			bias-pull-up;
+			drive-strength = <10>;
+		};
+
+		clk-pins {
+			pins = "sdc2_clk";
+			bias-disable;
+			drive-strength = <16>;
+		};
+	};
 };
 
 &uart12 {
-- 
2.47.3