Re: [PATCH v2 0/7] mfd: qcom-pm8008: Add support for PM8010 over I2C

[Burke Cates <burke.cates@gmail.com>]

On 14-Oct-26 16:01, Jishnu Prakash wrote:
> The series also adds support for skipping interrupt configurations
> which is needed to support SoCs where the PMIC's interrupt pin is
> grounded, such as Glymur.

Tested the series on an ASUS Zenbook A16 (UX3607OA, Snapdragon X2
Elite), on v7.3 plus out-of-tree Glymur platform/board patches. Its
PM8010 is described without an interrupt, so this exercises the
no-IRQ path:

  - The MFD and regulator drivers probe; the three LDOs the board
    uses for its two camera sensors (OV02C10 RGB, HM1092 IR) are off
    when idle and switch on only while a sensor streams.
  - Both sensors stream through CAMSS: RGB at 1080p30 for a 60 s soak
    with no dropped frames, and the IR sensor at 560x360.
  - Both cameras still capture after s2idle resume.

I didn't test regulator mode voting specifically, or a PM8008. Happy
to re-test v3.

Tested-by: Burke Cates <burke.cates@gmail.com> # ASUS Zenbook A16 (UX3607OA)

AI coding assistants helped run these tests and draft this reply; the
results are from the hardware runs.

Thanks,
Burke