From mboxrd@z Thu Jan 1 00:00:00 1970 From: Roman Byshko Subject: [PATCH 2/5] ARM: dtsi: sunxi: add common VBUS regulator Date: Mon, 27 Oct 2014 22:43:02 +0100 Message-ID: <210cc2a03d43e3d65b08f302b3b32663044ad94f.1414444953.git.rbyshko@gmail.com> References: Return-path: In-Reply-To: In-Reply-To: References: Sender: linux-kernel-owner@vger.kernel.org To: linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, devicetree@vger.kernel.org Cc: Kishon Vijay Abraham I , Maxime Ripard , Russell King , Kumar Gala , Ian Campbell , Mark Rutland , Pawel Moll , Rob Herring List-Id: devicetree@vger.kernel.org Until now the regulator nodes for powering USB VBUS existed only for the two host controllers. Now the regulator is added for USB OTG too. --- arch/arm/boot/dts/sunxi-common-regulators.dtsi | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/arch/arm/boot/dts/sunxi-common-regulators.dtsi b/arch/arm/boot/dts/sunxi-common-regulators.dtsi index c9c5b10..f521672 100644 --- a/arch/arm/boot/dts/sunxi-common-regulators.dtsi +++ b/arch/arm/boot/dts/sunxi-common-regulators.dtsi @@ -21,6 +21,13 @@ allwinner,pull = <0>; }; + usb0_vbus_pin_a: usb0_vbus_pin@0 { + allwinner,pins = "PB9"; + allwinner,function = "gpio_out"; + allwinner,drive = <0>; + allwinner,pull = <0>; + }; + usb1_vbus_pin_a: usb1_vbus_pin@0 { allwinner,pins = "PH6"; allwinner,function = "gpio_out"; @@ -49,6 +56,18 @@ status = "disabled"; }; + reg_usb0_vbus: usb0-vbus { + compatible = "regulator-fixed"; + pinctrl-names = "default"; + pinctrl-0 = <&usb0_vbus_pin_a>; + regulator-name = "usb0-vbus"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + enable-active-high; + gpio = <&pio 1 9 0>; + status = "disabled"; + }; + reg_usb1_vbus: usb1-vbus { compatible = "regulator-fixed"; pinctrl-names = "default"; -- 2.1.2