Re: [PATCH v3 10/11] ARM: dts: stm32: add ethernet1 for STM32MP135F-DK board

[Christophe ROULLIER <christophe.roullier@foss.st.com>]

On 6/3/24 15:08, Marek Vasut wrote:
> On 6/3/24 11:27 AM, Christophe Roullier wrote:
>> Ethernet1: RMII with crystal
>> PHY used is SMSC (LAN8742A)
>>
>> Signed-off-by: Christophe Roullier <christophe.roullier@foss.st.com>
>> ---
>>   arch/arm/boot/dts/st/stm32mp135f-dk.dts | 24 ++++++++++++++++++++++++
>>   1 file changed, 24 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/st/stm32mp135f-dk.dts 
>> b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
>> index 567e53ad285fa..cebe9b91eced9 100644
>> --- a/arch/arm/boot/dts/st/stm32mp135f-dk.dts
>> +++ b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
>> @@ -19,6 +19,7 @@ / {
>>       compatible = "st,stm32mp135f-dk", "st,stm32mp135";
>>         aliases {
>> +        ethernet0 = &ethernet1;
>>           serial0 = &uart4;
>>           serial1 = &usart1;
>>           serial2 = &uart8;
>> @@ -141,6 +142,29 @@ &cryp {
>>       status = "okay";
>>   };
>>   +&ethernet1 {
>> +    status = "okay";
>> +    pinctrl-0 = <&eth1_rmii_pins_a>;
>> +    pinctrl-1 = <&eth1_rmii_sleep_pins_a>;
>> +    pinctrl-names = "default", "sleep";
>> +    phy-mode = "rmii";
>> +    max-speed = <100>;
>
> Is this needed ? RMII cannot go faster than 100 .
>
ok (I will put in v4)
> Also, keep the list sorted alphabetically , P goes after M .
ok (I will put in v4)
>
>> +    phy-handle = <&phy0_eth1>;
>> +
>> +    mdio {
>> +        #address-cells = <1>;
>> +        #size-cells = <0>;
>> +        compatible = "snps,dwmac-mdio";
>> +
>> +        phy0_eth1: ethernet-phy@0 {
>> +            compatible = "ethernet-phy-id0007.c131";
>> +            reset-gpios =  <&mcp23017 9 GPIO_ACTIVE_LOW>;
>
> Extra space between = and < , please drop.
ok (I will put in v4)