Re: [PATCH v4 2/8] ASoC: qcom: sdm845: use DSP_A format for TDM codec DAIs

[Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>]

On 9/24/26 2:24 PM, David Heidelberg via B4 Relay wrote:
> From: David Heidelberg <david@ixit.cz>
> 
> Before the DSP_B only worked because the only close-to-mainline consumer
> cs35l36 codec was patched to map both DSP_A and DSP_B to the same
> hardware register value (asp_fmt = 0), which is inherently DSP_A timing.
> Use the right codec (DSP_A) which works as expected.
> 
> Signed-off-by: David Heidelberg <david@ixit.cz>
> ---

Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>

>  sound/soc/qcom/sdm845.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/sound/soc/qcom/sdm845.c b/sound/soc/qcom/sdm845.c
> index 0ce8265ab1c1f..d1cc825fc5cdc 100644
> --- a/sound/soc/qcom/sdm845.c
> +++ b/sound/soc/qcom/sdm845.c
> @@ -382,17 +382,17 @@ static int sdm845_snd_startup(struct snd_pcm_substream *substream)
>  	case QUATERNARY_TDM_RX_0:
>  	case QUATERNARY_TDM_TX_0:
>  		if (++(data->quat_tdm_clk_count) == 1) {
>  			snd_soc_dai_set_sysclk(cpu_dai,
>  				Q6AFE_LPASS_CLK_ID_QUAD_TDM_IBIT,
>  				TDM_BCLK_RATE, SNDRV_PCM_STREAM_PLAYBACK);
>  		}
>  
> -		codec_dai_fmt |= SND_SOC_DAIFMT_IB_NF | SND_SOC_DAIFMT_DSP_B;
> +		codec_dai_fmt |= SND_SOC_DAIFMT_IB_NF | SND_SOC_DAIFMT_DSP_A;
>  
>  		for_each_rtd_codec_dais(rtd, j, codec_dai) {
>  
>  			if (!strcmp(codec_dai->component->name_prefix,
>  				    "Left")) {
>  				ret = snd_soc_dai_set_fmt(
>  						codec_dai, codec_dai_fmt);
>  				if (ret < 0) {
>