Re: [PATCH v3 10/14] arm64: dts: qcom: lemans-evk: Enable first USB controller in device mode

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 9/4/25 6:39 PM, Wasim Nazir wrote:
> From: Krishna Kurapati <krishna.kurapati@oss.qualcomm.com>
> 
> Enable the first USB controller in device mode on the Lemans EVK
> board and configure the associated LDO regulators to power
> the PHYs accordingly.
> 
> The USB port is a Type-C port controlled by HD3SS3320 port controller.
> The role switch notifications would need to be routed to glue driver by
> adding an appropriate usb-c-connector node in DT. However in the design,
> the vbus supply that is to be provided to connected peripherals when
> port is configured as an DFP, is controlled by a GPIO.
> 
> There is also one ID line going from Port controller chip to GPIO-50 of
> the SoC. As per the datasheet of HD3SS3320:
> 
> "Upon detecting a UFP device, HD3SS3220 will keep ID pin high if VBUS is
> not at VSafe0V. Once VBUS is at VSafe0V, the HD3SS3220 will assert ID
> pin low. This is done to enforce Type-C requirement that VBUS must be
> at VSafe0V before re-enabling VBUS."
> 
> The current HD3SS3220 driver doesn't have this functionality present. So,
> putting the first USB controller in device mode for now. Once the vbus
> control based on ID pin is implemented in hd3ss3220.c, the
> usb-c-connector will be implemented and dr mode would be made OTG.

Hopefully that's somewhere on our todo list

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad