Re: [PATCH v7 4/4] clk: qcom: add clock controller driver for qca8386/qca8084

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 14/09/2023 07:46, Luo Jie wrote:
> The clock controller driver of qca8386/qca8084 is registered
> as the MDIO device, the hardware register is accessed by MDIO bus
> that is normally used to access general PHY device, which is
> different from the current existed qcom clock controller drivers
> using ioremap to access hardware clock registers.
> 
> MDIO bus is common utilized by both qca8386/qca8084 and other
> PHY devices, so the mutex lock mdio_bus->mdio_lock should be
> used instead of using the mutex lock of remap.
> 
> To access the hardware clock registers of qca8386/qca8084, there
> is special MDIO frame sequence(three MDIO read/write operations)
> need to be sent to device.
> 
> Signed-off-by: Luo Jie <quic_luoj@quicinc.com>
> ---
>  drivers/clk/qcom/Kconfig       |    9 +
>  drivers/clk/qcom/Makefile      |    1 +
>  drivers/clk/qcom/nsscc-qca8k.c | 2178 ++++++++++++++++++++++++++++++++
>  3 files changed, 2188 insertions(+)
>  create mode 100644 drivers/clk/qcom/nsscc-qca8k.c
> 
> diff --git a/drivers/clk/qcom/Kconfig b/drivers/clk/qcom/Kconfig
> index 865db5202e4c..c95ada6a1385 100644
> --- a/drivers/clk/qcom/Kconfig
> +++ b/drivers/clk/qcom/Kconfig
> @@ -203,6 +203,15 @@ config IPQ_GCC_9574
>  	  i2c, USB, SD/eMMC, etc. Select this for the root clock
>  	  of ipq9574.
>  
> +config IPQ_NSSCC_QCA8K
> +	tristate "QCA8K(QCA8386 or QCA8084) NSS Clock Controller"
> +	depends on MDIO_BUS || COMPILE_TEST

This is SoC is for both ARM and ARM64 worlds?

> +	help
> +	  Support for NSS(Network SubSystem) clock controller on
> +	  qca8386/qca8084 chip.
> +	  Say Y or M if you want to use network features of switch or
> +	  PHY device. Select this for the root clock of qca8k.
> +


Best regards,
Krzysztof