From: Maxim Storetvedt <mstoretv@cern.ch>
To: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>,
andersson@kernel.org, robh@kernel.org, krzk+dt@kernel.org,
conor+dt@kernel.org
Cc: marcus@nazgul.ch, marijn.suijten@somainline.org,
linux-arm-msm@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org, abel.vesa@linaro.org,
abel.vesa@oss.qualcomm.com, johan@kernel.org,
konradybcio@kernel.org, kirill@korins.ky
Subject: Re: [PATCH v6 3/3] arm64: dts: qcom: Add Samsung Galaxy Book4 Edge DTS/DTSI
Date: Wed, 25 Mar 2026 19:30:48 +0100 [thread overview]
Message-ID: <40e31e2f-84ff-425c-a7e9-f2df4210ddbc@cern.ch> (raw)
In-Reply-To: <881975ea-cc16-4b26-9672-731c146a1ba8@oss.qualcomm.com>
On 3/23/26 13:17, Konrad Dybcio wrote:
> On 3/22/26 5:03 PM, Maxim Storetvedt wrote:
>> Adds devicetrees for the 14-inch and 16-inch SKUs of the Samsung Galaxy Book4 Edge.
>>
>> These use a common dtsi derived from nodes that were able to work on Linux
>> from the initial Galaxy Book4 Edge DTS by Marcus:
>>
>> Link: https://lore.kernel.org/all/p3mhtj2rp6y2ezuwpd2gu7dwx5cbckfu4s4pazcudi4j2wogtr@4yecb2bkeyms/
>>
>> combined with the ongoing patch for the Honor Magicbook Art 14, and its downstream by
>> Valentin Manea, which shares device similarities:
>
> [...]
>
>> +&i2c8 {
>> + clock-frequency = <400000>;
>> +
>> + status = "okay";
>> +
>> + touchscreen@5d {
>> + compatible = "hid-over-i2c";
>> + reg = <0x5d>;
>> +
>> + hid-descr-addr = <0x1>;
>> + interrupts-extended = <&tlmm 34 IRQ_TYPE_LEVEL_LOW>;
>> +
>> + vdd-supply = <&vreg_misc_3p3>;
>> + /* Lower power supply is not enoug to work. */
>> + // vddl-supply = <&vreg_l15b_1p8>;
>
> How should we interpret that?
>
This was in the original patch, but using that same regulator appears to
be enough to also get touchscreen working on the 16" book4e. That said,
it still does not work on the 14". Something to revisit later...
>
> [...]
>
>> +&panel {
>> + compatible = "samsung,atna40cu07", "samsung,atna33xc20";
>
> I think it'd make sense to move the compatible from 'common' to the
> 16in DTS then too
>
>> + enable-gpios = <&pmc8380_3_gpios 4 GPIO_ACTIVE_HIGH>;
>
> this matches the common definition
>
>> + power-supply = <&vreg_edp_3p3>;
>
> ditto
>
>> + no-hpd;
>
> really??
>
One less thing to debug while previously attempting to work around the
"illegal link rate" error, which turned out to be related to eDP 1.4
(similar to the sp11). I've kept it as-is in case other SKUs attempt
booting from this dts, such as the x1e80100 16" (as it might be getting
a black screen using the current x1e84100 16" dts, though this is not
fully tested).
Worth mentioning is that we originally had two separate devicetrees for
the 14" and 16" SKUs, and the dts for the 16" eventually became this
dtsi. More could indeed still be cleaned and likewise moved to what is
now the 16" dts (i.e. for v7).
Cheers,
-Max
next prev parent reply other threads:[~2026-03-25 18:30 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-17 20:32 [PATCH v5 0/6] Add initial DTS for Samsung Galaxy Book4 Edge Marcus Glocker
2024-08-17 20:33 ` [PATCH v5 1/6] dt-bindings: crypto: Add X1E80100 Crypto Engine Marcus Glocker
2024-08-17 20:34 ` [PATCH v5 2/6] dt-bindings: phy: Add X1E80100 UFS Marcus Glocker
2024-08-17 20:36 ` [PATCH v5 3/6] dt-bindings: ufs: " Marcus Glocker
2024-08-18 6:41 ` Krzysztof Kozlowski
2024-08-17 20:38 ` [PATCH v5 4/6] arm64: dts: qcom: Add UFS node Marcus Glocker
2024-08-30 0:05 ` Konrad Dybcio
2024-08-30 17:25 ` Marcus Glocker
2024-11-09 23:31 ` Daniel Gomez
2025-01-02 21:38 ` Wesley Cheng
2025-01-02 23:17 ` Marcus Glocker
2026-03-07 16:01 ` Maxim Storetvedt
2026-03-08 20:35 ` Marcus Glocker
2026-03-19 11:31 ` Konrad Dybcio
2024-08-30 7:02 ` Johan Hovold
2024-08-17 20:40 ` [PATCH v5 5/6] dt-bindings: arm: Add Samsung Galaxy Book4 Edge Marcus Glocker
2024-08-17 20:41 ` [PATCH v5 6/6] arm64: dts: qcom: Add Samsung Galaxy Book4 Edge DTS Marcus Glocker
2026-03-22 16:03 ` [PATCH v6 0/3] Add initial DTS for Samsung Galaxy Book4 Edge Maxim Storetvedt
2026-03-22 16:03 ` [PATCH v6 1/3] firmware: qcom: scm: Allow QSEECOM on " Maxim Storetvedt
2026-03-22 18:40 ` Dmitry Baryshkov
2026-03-22 16:03 ` [PATCH v6 2/3] dt-bindings: arm: Add " Maxim Storetvedt
2026-03-26 11:44 ` Krzysztof Kozlowski
2026-03-26 18:40 ` Maxim Storetvedt
2026-03-22 16:03 ` [PATCH v6 3/3] arm64: dts: qcom: Add Samsung Galaxy Book4 Edge DTS/DTSI Maxim Storetvedt
2026-03-23 12:17 ` Konrad Dybcio
2026-03-25 18:30 ` Maxim Storetvedt [this message]
2026-03-26 11:33 ` Konrad Dybcio
2026-03-26 18:30 ` Maxim Storetvedt
2026-03-30 10:41 ` Konrad Dybcio
2026-03-30 10:54 ` Dmitry Baryshkov
2026-03-31 16:34 ` Maxim Storetvedt
2026-04-07 11:55 ` Konrad Dybcio
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=40e31e2f-84ff-425c-a7e9-f2df4210ddbc@cern.ch \
--to=mstoretv@cern.ch \
--cc=abel.vesa@linaro.org \
--cc=abel.vesa@oss.qualcomm.com \
--cc=andersson@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=johan@kernel.org \
--cc=kirill@korins.ky \
--cc=konrad.dybcio@oss.qualcomm.com \
--cc=konradybcio@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=marcus@nazgul.ch \
--cc=marijn.suijten@somainline.org \
--cc=robh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox