Re: [PATCH 3/3] arm64: dts: qcom: sm8650: Add DisplayPort device nodes

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 12/7/23 17:37, Neil Armstrong wrote:
> Declare the displayport controller present on the Qualcomm SM8650 SoC
> and connected to the USB3/DP Combo PHY.
> 
> Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>
> ---
[...]

> +				clocks = <&dispcc DISP_CC_MDSS_AHB_CLK>,
> +					 <&dispcc DISP_CC_MDSS_DPTX0_AUX_CLK>,
> +					 <&dispcc DISP_CC_MDSS_DPTX0_LINK_CLK>,
> +					 <&dispcc DISP_CC_MDSS_DPTX0_LINK_INTF_CLK>,
> +					 <&dispcc DISP_CC_MDSS_DPTX0_PIXEL0_CLK>;
What about PIXEL1 clocks?

[...]

> +					opp-162000000 {
> +						opp-hz = /bits/ 64 <162000000>;
> +						required-opps = <&rpmhpd_opp_low_svs_d1>;
> +					};
> +
> +					opp-270000000 {
> +						opp-hz = /bits/ 64 <270000000>;
> +						required-opps = <&rpmhpd_opp_low_svs>;
> +					};
> +
> +					opp-540000000 {
> +						opp-hz = /bits/ 64 <540000000>;
> +						required-opps = <&rpmhpd_opp_svs_l1>;
> +					};
> +
> +					opp-810000000 {
> +						opp-hz = /bits/ 64 <810000000>;
> +						required-opps = <&rpmhpd_opp_nom>;
> +					};
> +				};
> +			};
>   		};
>   
>   		dispcc: clock-controller@af00000 {
> @@ -2996,8 +3086,8 @@ dispcc: clock-controller@af00000 {
>   				 <&mdss_dsi0_phy 1>,
>   				 <&mdss_dsi1_phy 0>,
>   				 <&mdss_dsi1_phy 1>,
> -				 <0>, /* dp0 */
> -				 <0>,
> +				 <&usb_dp_qmpphy QMP_USB43DP_DP_LINK_CLK>,
> +				 <&usb_dp_qmpphy QMP_USB43DP_DP_VCO_DIV_CLK>,
>   				 <0>, /* dp1 */
>   				 <0>,
>   				 <0>, /* dp2 */
I noticed that this is not in line with your mdss patch [1]
where there are only two DP INTFs available.. Unless all of
these controllers can work using some sharing/only some at
one time...

Konrad

[1] https://lore.kernel.org/all/20231030-topic-sm8650-upstream-mdss-v2-5-43f1887c82b8@linaro.org/