devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Nicolas Ferre <nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
To: Jamie Iles <jamie-wmLquQDDieKakBO8gow8eQ@public.gmane.org>
Cc: netdev-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org,
	linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
	linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org
Subject: Re: [PATCH] net/macb: add DT support
Date: Fri, 02 Dec 2011 18:53:58 +0100	[thread overview]
Message-ID: <4ED910B6.7080000@atmel.com> (raw)
In-Reply-To: <20111202172854.GB4998@totoro>

On 12/02/2011 06:28 PM, Jamie Iles :
> Hi Nicolas,
>
> On Fri, Dec 02, 2011 at 06:14:10PM +0100, Nicolas Ferre wrote:
>> From: Jean-Christophe PLAGNIOL-VILLARD<plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
>>
>> Allow the device tree to provide the mac address and the phy mode.
>>
>> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD<plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
>> [nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org: change "compatible" node property, doc and DT hwaddr]
>> Signed-off-by: Nicolas Ferre<nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
>> Cc: Jamie Iles<jamie-wmLquQDDieKakBO8gow8eQ@public.gmane.org>
>
> Looks nice to me.  There's a patch below to add the GEM stuff to the
> binding too if you want to role that in.

Yes, I will push it in a "v3" (I was busy correcting a bug and did not 
see your answer before sending v2...).

> Acked-by: Jamie Iles<jamie-wmLquQDDieKakBO8gow8eQ@public.gmane.org>
>
> 8<----
>
> diff --git a/Documentation/devicetree/bindings/net/macb.txt b/Documentation/devicetree/bindings/net/macb.txt
> index 7f0b90a..e09e3fb 100644
> --- a/Documentation/devicetree/bindings/net/macb.txt
> +++ b/Documentation/devicetree/bindings/net/macb.txt
> @@ -1,9 +1,11 @@
> -* Cadence MACB Ethernet controller
> +* Cadence MACB/GEM Ethernet controller
>
>   Required properties:
> -- compatible: Should be "cdns,[<chip>-]macb"
> +- compatible: Should be "cdns,[<chip>-]{macb,gem}"
>     Use "cdns,at91sam9260-macb" Atmel at91sam9260 and at91sam9263 SoCs.
>     Use "cdns,at32ap7000-macb" for other 10/100 usage or use the generic form: "cdns,macb"
> +  Use "cnds,pc302-gem" for Picochip picoXcell pc302 and later devices based on
> +  the Cadence GEM, or the generic form "cdns,gem".
>   - reg: Address and length of the register set for the device
>   - interrupts: Should contain macb interrupt
>   - phy-mode: String, operation mode of the PHY interface.
> diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
> index 103c6e6..89060e6 100644
> --- a/drivers/net/ethernet/cadence/macb.c
> +++ b/drivers/net/ethernet/cadence/macb.c
> @@ -1247,6 +1247,8 @@ static const struct of_device_id macb_dt_ids[] = {
>   	{ .compatible = "cdns,at32ap7000-macb" },
>   	{ .compatible = "cdns,at91sam9260-macb" },
>   	{ .compatible = "cdns,macb" },
> +	{ .compatible = "cdns,pc302-gem" },
> +	{ .compatible = "cdns,gem" },
>   	{ /* sentinel */ }
>   };

BTW, I think we may also modify the MII/RMII selection code for adding 
gigabit selection... but maybe you already have the patches?

Best regards,
-- 
Nicolas Ferre

  reply	other threads:[~2011-12-02 17:53 UTC|newest]

Thread overview: 24+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2011-11-18 14:29 [PATCH 1/1] net/macb: add DT support Jean-Christophe PLAGNIOL-VILLARD
2011-11-18 15:58 ` Jamie Iles
2011-11-20 16:47   ` Jean-Christophe PLAGNIOL-VILLARD
2011-11-20 17:11     ` Jamie Iles
2011-11-21 10:08       ` Nicolas Ferre
2011-12-02 15:30       ` Nicolas Ferre
2011-12-02 15:38         ` Jamie Iles
2011-12-02 17:14           ` [PATCH] " Nicolas Ferre
     [not found]             ` <1322846050-4543-1-git-send-email-nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
2011-12-02 17:28               ` Jamie Iles
2011-12-02 17:53                 ` Nicolas Ferre [this message]
2011-12-05 11:48                   ` Jamie Iles
2011-12-05 11:51                     ` Nicolas Ferre
2011-12-02 17:43               ` [PATCH v2] " Nicolas Ferre
2011-12-02 17:58                 ` David Miller
     [not found]                   ` <20111202.125832.1208514279272697863.davem-fT/PcQaiUtIeIZ0/mPfg9Q@public.gmane.org>
2011-12-05 11:36                     ` Nicolas Ferre
     [not found]                 ` <1322847782-22650-1-git-send-email-nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
2011-12-02 17:50                   ` [PATCH] ARM: at91/net: add macb ethernet controller in 9g45 DT Nicolas Ferre
2011-12-03  5:56                     ` Jean-Christophe PLAGNIOL-VILLARD
     [not found]                       ` <20111203055659.GL18533-RQcB7r2h9QmfDR2tN2SG5Ni2O/JbrIOy@public.gmane.org>
2011-12-05 11:39                         ` Nicolas Ferre
2011-12-05 11:59                   ` [PATCH v3 1/2] net/macb: add DT support for Cadence macb/gem driver Nicolas Ferre
2011-12-05 11:59                     ` [PATCH v3 2/2] ARM: at91/net: add macb ethernet controller in 9g45 DT Nicolas Ferre
2011-12-05 15:25                       ` Jean-Christophe PLAGNIOL-VILLARD
2011-12-07 13:49                     ` [PATCH v3 1/2] net/macb: add DT support for Cadence macb/gem driver Nicolas Ferre
2011-12-07 18:27                     ` David Miller
2011-11-21 11:08 ` [PATCH 1/1] net/macb: add DT support Nicolas Ferre

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=4ED910B6.7080000@atmel.com \
    --to=nicolas.ferre-aife0yeh4naavxtiumwx3w@public.gmane.org \
    --cc=devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org \
    --cc=jamie-wmLquQDDieKakBO8gow8eQ@public.gmane.org \
    --cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
    --cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=netdev-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).