Re: [PATCH 2/5 v3] ARM: at91: sam9g20 add i2c DT support

[Rob Herring <robherring2-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>]

On 03/08/2012 02:50 AM, Jean-Christophe PLAGNIOL-VILLARD wrote:
> For now on use i2c-gpio driver on the same pin as the hardware IP.
> 
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
> Cc: Nicolas Ferre <nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
> Cc: devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org
> ---
> v3:
> 
> 	update i2c binding (Rob comments)
> 
> Best Regards,
> J.
>  arch/arm/boot/dts/at91sam9g20.dtsi |   13 +++++++++++++
>  1 files changed, 13 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/at91sam9g20.dtsi b/arch/arm/boot/dts/at91sam9g20.dtsi
> index 4b0dc99..072b2da 100644
> --- a/arch/arm/boot/dts/at91sam9g20.dtsi
> +++ b/arch/arm/boot/dts/at91sam9g20.dtsi
> @@ -189,4 +189,17 @@
>  			status = "disabled";
>  		};
>  	};
> +
> +	i2c-gpio@0 {

You updated the example, but not all the actual uses to i2c@0.

Rob

> +		compatible = "i2c-gpio";
> +		gpios = <&pioA 23 0 /* sda */
> +			 &pioA 24 0 /* scl */
> +			>;
> +		i2c-gpio,sda-open-drain;
> +		i2c-gpio,scl-open-drain;
> +		i2c-gpio,delay-us = <2>;	/* ~100 kHz */
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +		status = "disabled";
> +	};
>  };