devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Nicolas Ferre <nicolas.ferre-AIFe0yeh4nAAvxtiuMwx3w@public.gmane.org>
Cc: "Vinod Koul" <vinod.koul-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org>,
	devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org,
	"Rob Herring"
	<rob.herring-bsGFqQB8/DxBDgjK7y7TUQ@public.gmane.org>,
	kernel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org,
	"Uwe Kleine-König"
	<u.kleine-koenig-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>,
	"Dan Williams"
	<dan.j.williams-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org>,
	linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org
Subject: Re: [PATCH 07/11] dmaengine: at_hdmac: add a few const qualifiers
Date: Fri, 13 Jul 2012 15:54:27 +0200	[thread overview]
Message-ID: <50002893.6030700@atmel.com> (raw)
In-Reply-To: <1342182734-321-9-git-send-email-y>

On 07/13/2012 02:32 PM, y@pengutronix.de :
> From: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
> 
> This prepares of_device_id.data becoming const. Without this change
> the following warning would occur:
> 
> 	drivers/dma/at_hdmac.c: In function 'at_dma_get_driver_data':
> 	drivers/dma/at_hdmac.c:1228: warning: return discards qualifiers from pointer target type
> 
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
> Cc: Nicolas Ferre <nicolas.ferre@atmel.com>

Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

> Cc: Dan Williams <dan.j.williams@intel.com>
> Cc: Vinod Koul <vinod.koul@intel.com>
> ---
>  drivers/dma/at_hdmac.c |    4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/dma/at_hdmac.c b/drivers/dma/at_hdmac.c
> index 7292aa8..7e9d265 100644
> --- a/drivers/dma/at_hdmac.c
> +++ b/drivers/dma/at_hdmac.c
> @@ -1217,7 +1217,7 @@ static const struct platform_device_id atdma_devtypes[] = {
>  	}
>  };
>  
> -static inline struct at_dma_platform_data * __init at_dma_get_driver_data(
> +static inline const struct at_dma_platform_data * __init at_dma_get_driver_data(
>  						struct platform_device *pdev)
>  {
>  	if (pdev->dev.of_node) {
> @@ -1255,7 +1255,7 @@ static int __init at_dma_probe(struct platform_device *pdev)
>  	int			irq;
>  	int			err;
>  	int			i;
> -	struct at_dma_platform_data *plat_dat;
> +	const struct at_dma_platform_data *plat_dat;
>  
>  	/* setup platform data for each SoC */
>  	dma_cap_set(DMA_MEMCPY, at91sam9rl_config.cap_mask);
> 


-- 
Nicolas Ferre


_______________________________________________
devicetree-discuss mailing list
devicetree-discuss@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/devicetree-discuss

  parent reply	other threads:[~2012-07-13 13:54 UTC|newest]

Thread overview: 31+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <1342182734-321-1-git-send-email-y>
2012-07-13 12:32 ` [PATCH 0/9] make struct of_device_id.data const y
2012-07-13 12:32 ` [PATCH 01/11] spi/imx: make spi_imx_data.devtype_data member point to const data y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` [PATCH 02/11] serial/imx: make imx_port.devdata " y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` [PATCH 03/11] ARM: cache-l2x0: add a const qualifier y
2012-07-13 12:32 ` [PATCH 04/11] misc/atmel_tc: make atmel_tc.tcb_config member point to const data y
2012-07-13 12:32 ` [PATCH 05/11] gpio/gpio-omap.c: add a const qualifier y
2012-07-13 12:32 ` [PATCH 06/11] i2c/i2c-omap: " y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` [PATCH 07/11] dmaengine: at_hdmac: add a few const qualifiers y
2012-07-13 12:32 ` [PATCH 08/11] spi/spi-omap2-mcspi: add a const qualifier y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` [PATCH 09/11] mmc/omap_hsmmc: " y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` y
2012-07-13 12:32 ` [PATCH 10/11] of: add const to struct of_device_id.data y
2012-07-13 12:32 ` [PATCH 11/11] gpio/gpio-omap: make platformdata used as of_device_id.data const y
2012-07-13 12:39 ` [PATCH 00/11] make struct " Uwe Kleine-König
2012-07-13 12:41 ` Rob Herring
     [not found]   ` <5000175E.4070702-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2012-07-13 13:46     ` Uwe Kleine-König
     [not found]       ` <20120713134638.GH592-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2012-07-13 16:24         ` Arnd Bergmann
     [not found]           ` <201207131624.27266.arnd-r2nGTMty4D4@public.gmane.org>
2012-07-13 17:49             ` Uwe Kleine-König
     [not found]               ` <20120713174935.GN592-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2012-07-13 18:56                 ` Arnd Bergmann
2012-07-13 19:48                 ` Rob Herring
2012-07-13 19:36     ` Grant Likely
     [not found]       ` <CACxGe6tXvz+rt2yrHHaD=j94-=JQEh06sHW0FWGiHb2=9GS2pA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2012-07-14 18:31         ` Uwe Kleine-König
     [not found] ` <1342182734-321-6-git-send-email-y>
2012-07-13 13:40   ` [PATCH 04/11] misc/atmel_tc: make atmel_tc.tcb_config member point to const data Nicolas Ferre
     [not found] ` <1342182734-321-9-git-send-email-y>
2012-07-13 13:54   ` Nicolas Ferre [this message]
2012-07-16  6:38   ` [PATCH 07/11] dmaengine: at_hdmac: add a few const qualifiers Vinod Koul

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=50002893.6030700@atmel.com \
    --to=nicolas.ferre-aife0yeh4naavxtiumwx3w@public.gmane.org \
    --cc=dan.j.williams-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org \
    --cc=devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org \
    --cc=kernel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org \
    --cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
    --cc=rob.herring-bsGFqQB8/DxBDgjK7y7TUQ@public.gmane.org \
    --cc=u.kleine-koenig-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org \
    --cc=vinod.koul-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).