From mboxrd@z Thu Jan 1 00:00:00 1970 From: Benoit Cousson Subject: Re: [PATCH v3 0/3] ARM/dts: omap3: Add DT support for IGEP devices Date: Wed, 12 Dec 2012 11:11:28 +0100 Message-ID: <50C85850.7010906@ti.com> References: <1354538503-22671-1-git-send-email-javier.martinez@collabora.co.uk> Mime-Version: 1.0 Content-Type: text/plain; charset="UTF-8" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: Sender: linux-kernel-owner@vger.kernel.org To: Javier Martinez Canillas Cc: Tony Lindgren , grant.likely@secretlab.ca, Enric Balletbo i Serra , Ezequiel Garcia , Enrico Butera , Matthias Brugger , linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org, devicetree-discuss@lists.ozlabs.org, linux-kernel@vger.kernel.org List-Id: devicetree@vger.kernel.org Hi Javier, On 12/12/2012 09:25 AM, Javier Martinez Canillas wrote: > On Mon, Dec 3, 2012 at 1:41 PM, Javier Martinez Canillas > wrote: >> IGEP technology devices are TI OMAP3 SoC based industrial embedded >> and computer-on-module boards. This patch-set adds initial device >> tree support for these devices. >> >> The device trees allows to boot from an MMC and are working all the >> components that already have device tree support on OMAP3 SoCs: >> >> - MMC/SD >> - UARTs >> - GPIO LEDs >> - TWL4030 codec audio >> - pinmux/pinconf pinctrl >> >> Some peripheral are still not working such as Flash storage and >> Ethernet but support for these will also be included once the >> OMAP GPMC device tree binding patches land on mainline. >> >> This is a v3 of the patch-set that solves issues pointed out by >> Enric Balletbo and Benoit Cousson. >> >> The patch-set is composed of the following patches: >> >> [PATCH v3 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices >> [PATCH v3 2/3] ARM/dts: omap3: Add support for IGEPv2 board >> [PATCH v3 3/3] ARM/dts: omap3: Add support for IGEP COM Module >> >> Best regards, >> Javier >> -- > > Hi Benoit and Tony, > > Any comments on these? Nope, that's fine. I'll applied the series for 3.9. Thanks, Benoit