Re: [PATCH v3 3/3] ARM: dts: dra7-evm: Add extcon nodes for USB ID pin detection

[Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>]

On 08/28/2013 09:33 PM, George Cherian wrote:

> Add
> 	-extcon nodes for USB ID pin detection.
> 	-i2c nodes.
> 	-pcf nodes to which USB ID pin is connected.

> Signed-off-by: George Cherian <george.cherian@ti.com>
> ---
>   arch/arm/boot/dts/dra7-evm.dts | 50 +++++++++++++++++++++++++++++++++++++++++-
>   1 file changed, 49 insertions(+), 1 deletion(-)

> diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
> index acd3c09..8b0738a 100644
> --- a/arch/arm/boot/dts/dra7-evm.dts
> +++ b/arch/arm/boot/dts/dra7-evm.dts
[...]
> @@ -33,10 +44,47 @@
>           };
>   };
>
> +&i2c1 {
> +	clock-frequency = <400000>;
> +
> +	gpio20: pcf8575@20 {

     ePAPR was talking about the node naming, not about labelling. Back to the 
drawing board. ;-)

> +		compatible = "ti,pcf8575";
> +		reg = <0x20>;
> +		n_latch = <0x4000>;
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +		interrupt-parent = <&gpio6>;
> +		interrupts = <11 2>;
> +		interrupt-controller;
> +		#interrupt-cells = <2>;
> +	};
> +
> +	gpio21: pcf8575@21 {
> +		compatible = "ti,pcf8575";
> +		reg = <0x21>;
> +		n_latch = <0x1408>;
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +		interrupt-parent = <&pcf_20>;
> +		interrupts = <14 2>;
> +		interrupt-controller;
> +		#interrupt-cells = <2>;
> +	};
> +
> +};
> +

WBR, Sergei