From mboxrd@z Thu Jan 1 00:00:00 1970 From: Santosh Shilimkar Subject: Re: [Patch v4 2/5] Power: reset: add bindings for keystone reset driver Date: Wed, 21 May 2014 12:09:50 -0400 Message-ID: <537CCFCE.7070701@ti.com> References: <1400682454-24535-1-git-send-email-ivan.khoronzhuk@ti.com> <5023955.Vhmhn25HgF@wuerfel> <537CCE5A.7030909@ti.com> <13696681.6eGQ96hCX4@wuerfel> Mime-Version: 1.0 Content-Type: text/plain; charset="ISO-8859-1" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <13696681.6eGQ96hCX4@wuerfel> Sender: linux-doc-owner@vger.kernel.org To: Arnd Bergmann , Ivan Khoronzhuk Cc: dbaryshkov@gmail.com, dwmw2@infradead.org, robh+dt@kernel.org, pawel.moll@arm.com, mark.rutland@arm.com, ijc+devicetree@hellion.org.uk, galak@codeaurora.org, grant.likely@linaro.org, rdunlap@infradead.org, linux@arm.linux.org.uk, grygorii.strashko@ti.com, olof@lixom.net, w-kwok2@ti.com, sboyd@codeaurora.org, devicetree@vger.kernel.org, linux-doc@vger.kernel.org, linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, m-karicheri2@ti.com List-Id: devicetree@vger.kernel.org On Wednesday 21 May 2014 12:07 PM, Arnd Bergmann wrote: > On Wednesday 21 May 2014 19:03:38 Ivan Khoronzhuk wrote: >> >> I've slightly confused where should I add these bindings. >> The main pll controller mostly used by clk driver.... >> As its register set is used also by reset driver it's logically to put >> it to bindings/mfd, >> but pll controller in mfd it's strange.... >> >> Could you please help to decide where should it be?. > > Put it into Documentation/devicetree/bindings/clock/keystone-pll.txt > I was just about post the same suggestion. Lets do that. regards, Santosh