From: "Andreas Färber" <afaerber@suse.de>
To: Ajay kumar <ajaynumb@gmail.com>, Doug Anderson <dianders@chromium.org>
Cc: "Ajay Kumar" <ajaykumar.rs@samsung.com>,
"dri-devel@lists.freedesktop.org"
<dri-devel@lists.freedesktop.org>,
"linux-samsung-soc@vger.kernel.org"
<linux-samsung-soc@vger.kernel.org>,
"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
"Vincent Palatin" <vpalatin@chromium.org>,
"InKi Dae" <inki.dae@samsung.com>,
"Sean Paul" <seanpaul@google.com>,
"Rob Clark" <robdclark@gmail.com>,
"Daniel Vetter" <daniel.vetter@ffwll.ch>,
"Thierry Reding" <thierry.reding@gmail.com>,
"sunil joshi" <joshi@samsung.com>,
"Prashanth G" <prashanth.g@samsung.com>,
"Stéphane Marchesin" <marcheu@chromium.org>,
"Rahul Sharma" <rahul.sharma@samsung.com>
Subject: Re: [PATCH V4 00/10] drm: exynos: few patches to enhance bridge chip support
Date: Fri, 04 Jul 2014 15:06:56 +0200 [thread overview]
Message-ID: <53B6A6F0.1070108@suse.de> (raw)
In-Reply-To: <CAEC9eQPee1CYQa01V93pTwwNbAZ=h5wVznQ-_PGoWmxSZV3Tbg@mail.gmail.com>
Hi Ajay,
Am 03.07.2014 16:55, schrieb Ajay kumar:
> On Thu, Jul 3, 2014 at 10:49 AM, Andreas Färber <afaerber@suse.de> wrote:
>> Am 11.06.2014 20:26, schrieb Ajay Kumar:
>>> This series is based on exynos-drm-next branch of Inki Dae's tree at:
>>> git://git.kernel.org/pub/scm/linux/kernel/git/daeinki/drm-exynos.git
>>>
>>> I have tested this after adding few DT changes for exynos5250-snow,
>>> exynos5420-peach-pit and exynos5800-peach-pi boards.
>>
>> Unfortunately this series per se does not yet fix my display issues on
>> the Spring Chromebook. Can you share what dt changes you made for Snow?
>>
>> Before, if the dp-controller dt node was present, I would get a dark
>> screen immediately and I could ssh into the system shortly after.
>> I worked around that by commenting the node out, which would allow me to
>> graphically boot pretty much instantly.
>>
>> With these 10 patches applied on top of my dt on top of kgene's tree,
>> the last U-Boot screen stays visible for ~50 seconds, then the screen
>> goes blank, and I can ssh in some time later.
>> If I comment out the dp-controller node again, it takes long for the
>> kernel boot to graphically proceed but works okay then.
>> In both cases there's a gap of ~2900 seconds visible in dmesg.
[...]
>> https://github.com/afaerber/linux/commits/spring-next
>> https://github.com/afaerber/u-boot/commits/spring
> You need to add bridge chip node and panel node to use my patch series.
> Also, to support that you need to enable tps65090 regulator on spring.
>
> I have attached a patch which adds the bridge chip node and panel node.
Wow, that's more help than I expected! Many thanks.
I'll strip down dp-controller accordingly for my v2.
Your dt changes level again with my commenting out dp-controller. So I
take it, the minute-long delay is regulator-induced somehow.
> Also, I have attached a sample config which I used to compile the kernel.
I simply answered y to all your new options. :)
> Doug can help you in adding changes required for tps65090.
Hm, Doug had pointed out an issue with tps65090 in my v1, so I dropped
it: https://patchwork.kernel.org/patch/4397321/
Regards,
Andreas
--
SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany
GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer; HRB 16746 AG Nürnberg
next prev parent reply other threads:[~2014-07-04 13:06 UTC|newest]
Thread overview: 41+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-06-11 18:26 [PATCH V4 00/10] drm: exynos: few patches to enhance bridge chip support Ajay Kumar
2014-06-11 18:26 ` [PATCH V4 01/10] drm/exynos: Move DP setup out of hotplug workqueue Ajay Kumar
2014-06-20 8:07 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 02/10] drm/panel: add prepare and unprepare routines Ajay Kumar
2014-06-20 8:07 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 03/10] drm/exynos: dp: modify driver to support drm_panel Ajay Kumar
2014-06-20 8:08 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 04/10] drm/panel: Add driver for lvds/edp based panels Ajay Kumar
2014-06-20 8:07 ` Ajay kumar
[not found] ` <1402511228-18945-5-git-send-email-ajaykumar.rs-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2014-06-23 15:30 ` Javier Martinez Canillas
2014-06-24 8:18 ` Ajay kumar
2014-06-23 16:55 ` Christian Gmeiner
2014-06-24 8:22 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 05/10] drm/bridge: add helper functions to support bridge chain Ajay Kumar
2014-06-20 8:07 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 06/10] drm/bridge: Add a driver which binds drm_bridge with drm_panel Ajay Kumar
[not found] ` <1402511228-18945-7-git-send-email-ajaykumar.rs-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2014-06-20 8:08 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 07/10] drm/bridge: ptn3460: Support bridge chaining Ajay Kumar
2014-06-20 8:09 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 08/10] drm/exynos: dp: create bridge chain using ptn3460 and panel_binder Ajay Kumar
2014-06-20 8:09 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 09/10] drm/bridge: Add ps8622/ps8625 bridge driver Ajay Kumar
2014-06-20 8:09 ` Ajay kumar
2014-06-23 16:05 ` Javier Martinez Canillas
2014-06-24 8:15 ` Ajay kumar
2014-06-11 18:27 ` [PATCH V4 10/10] drm/exynos: Add ps8622 lvds bridge discovery to DP driver Ajay Kumar
2014-06-20 8:09 ` Ajay kumar
2014-06-20 8:06 ` [PATCH V4 00/10] drm: exynos: few patches to enhance bridge chip support Ajay kumar
2014-06-20 15:51 ` Inki Dae
2014-06-23 13:58 ` Rahul Sharma
2014-06-23 14:38 ` Tomasz Figa
2014-06-24 3:25 ` Rahul Sharma
2014-06-23 16:15 ` Javier Martinez Canillas
2014-07-03 5:19 ` Andreas Färber
2014-07-03 14:55 ` Ajay kumar
2014-07-04 13:06 ` Andreas Färber [this message]
2014-07-07 20:27 ` Doug Anderson
2014-07-07 20:46 ` Doug Anderson
2014-07-09 6:11 ` Ajay kumar
2014-07-14 17:22 ` Olof Johansson
2014-07-15 5:37 ` Inki Dae
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=53B6A6F0.1070108@suse.de \
--to=afaerber@suse.de \
--cc=ajaykumar.rs@samsung.com \
--cc=ajaynumb@gmail.com \
--cc=daniel.vetter@ffwll.ch \
--cc=devicetree@vger.kernel.org \
--cc=dianders@chromium.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=inki.dae@samsung.com \
--cc=joshi@samsung.com \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=marcheu@chromium.org \
--cc=prashanth.g@samsung.com \
--cc=rahul.sharma@samsung.com \
--cc=robdclark@gmail.com \
--cc=seanpaul@google.com \
--cc=thierry.reding@gmail.com \
--cc=vpalatin@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).