Re: [PATCH v3 3/4] dt-bindings: can: m_can: Include reference to new fixed transceiver binding

[Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>]

On 8/3/2017 3:51 AM, Franklin S Cooper Jr wrote:

> Add information regarding fixed transceiver binding. This is especially
> important for MCAN since the IP allows CAN FD mode to run significantly
> faster than what most transceivers are capable of.
> 
> Signed-off-by: Franklin S Cooper Jr <fcooper@ti.com>
> ---
>   Documentation/devicetree/bindings/net/can/m_can.txt | 9 +++++++++
>   1 file changed, 9 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/can/m_can.txt b/Documentation/devicetree/bindings/net/can/m_can.txt
> index 9e33177..0b62f47 100644
> --- a/Documentation/devicetree/bindings/net/can/m_can.txt
> +++ b/Documentation/devicetree/bindings/net/can/m_can.txt
> @@ -43,6 +43,11 @@ Required properties:
>   			  Please refer to 2.4.1 Message RAM Configuration in
>   			  Bosch M_CAN user manual for details.
>   
> +Optional properties:
> +- fixed-transceiver	: Fixed-transceiver subnode describing maximum speed

    Subnode is not a property.

> +			  that can be used for CAN/CAN-FD modes. See
> +			  Documentation/devicetree/bindings/net/can/fixed-transceiver.txt
> +			  for details.
>   Example:
>   SoC dtsi:
>   m_can1: can@020e8000 {
> @@ -64,4 +69,8 @@ Board dts:
>   	pinctrl-names = "default";
>   	pinctrl-0 = <&pinctrl_m_can1>;
>   	status = "enabled";
> +
> +	fixed-transceiver@0 {

    Same comments here as in previous patch.

[...]

MBR, Sergei