From: <Claudiu.Beznea@microchip.com>
To: <Sergiu.Moga@microchip.com>, <lee@kernel.org>,
<robh+dt@kernel.org>, <krzysztof.kozlowski+dt@linaro.org>,
<Nicolas.Ferre@microchip.com>, <alexandre.belloni@bootlin.com>,
<radu_nicolae.pirea@upb.ro>, <richard.genoud@gmail.com>,
<gregkh@linuxfoundation.org>, <broonie@kernel.org>,
<mturquette@baylibre.com>, <sboyd@kernel.org>,
<jirislaby@kernel.org>, <admin@hifiphile.com>,
<Kavyasree.Kotagiri@microchip.com>, <Tudor.Ambarus@microchip.com>
Cc: <devicetree@vger.kernel.org>,
<linux-arm-kernel@lists.infradead.org>,
<linux-kernel@vger.kernel.org>, <linux-spi@vger.kernel.org>,
<linux-serial@vger.kernel.org>, <linux-clk@vger.kernel.org>
Subject: Re: [PATCH v3 02/14] ARM: dts: at91: sam9x60ek: Add DBGU compatibles to uart1
Date: Fri, 16 Sep 2022 08:14:49 +0000 [thread overview]
Message-ID: <53e72e5d-47fc-403d-c969-61b267a9ff15@microchip.com> (raw)
In-Reply-To: <20220913142205.162399-3-sergiu.moga@microchip.com>
On 13.09.2022 17:21, Sergiu Moga wrote:
> Maintain consistency among the compatibles of the serial nodes of
> sam9x60ek and highlight the incremental characteristic of its serial
> IP's by making sure that all serial nodes contain both the sam9x60
> and sam9260 usart/dbgu compatibles.
>
> Signed-off-by: Sergiu Moga <sergiu.moga@microchip.com>
Applied to at91-dt, thanks!
> ---
>
>
> v1 -> v2:
> - Nothing, this patch was not here before
>
>
> v2 -> v3:
> - Nothing, previously this was [PATCH 4]
>
>
>
> arch/arm/boot/dts/at91-sam9x60ek.dts | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/at91-sam9x60ek.dts b/arch/arm/boot/dts/at91-sam9x60ek.dts
> index 7ade9979e1c6..67bce8d60908 100644
> --- a/arch/arm/boot/dts/at91-sam9x60ek.dts
> +++ b/arch/arm/boot/dts/at91-sam9x60ek.dts
> @@ -258,7 +258,7 @@ &flx5 {
> status = "okay";
>
> uart1: serial@200 {
> - compatible = "microchip,sam9x60-usart", "atmel,at91sam9260-usart";
> + compatible = "microchip,sam9x60-dbgu", "microchip,sam9x60-usart", "atmel,at91sam9260-dbgu", "atmel,at91sam9260-usart";
> reg = <0x200 0x200>;
> interrupts = <14 IRQ_TYPE_LEVEL_HIGH 7>;
> dmas = <&dma0
next prev parent reply other threads:[~2022-09-16 8:15 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-09-13 14:21 [PATCH v3 00/14] Make atmel serial driver aware of GCLK Sergiu Moga
2022-09-13 14:21 ` [PATCH v3 01/14] ARM: dts: at91: sama7g5: Swap rx and tx for spi11 Sergiu Moga
2022-09-16 8:13 ` Claudiu.Beznea
2022-09-13 14:21 ` [PATCH v3 02/14] ARM: dts: at91: sam9x60ek: Add DBGU compatibles to uart1 Sergiu Moga
2022-09-16 8:14 ` Claudiu.Beznea [this message]
2022-09-13 14:21 ` [PATCH v3 03/14] ARM: dts: at91: Add `atmel,usart-mode` required property to serial nodes Sergiu Moga
2022-09-16 8:15 ` Claudiu.Beznea
2022-09-13 14:21 ` [PATCH v3 04/14] spi: dt-bindings: atmel,at91rm9200-spi: Add DMA related properties Sergiu Moga
2022-09-16 8:15 ` Claudiu.Beznea
2022-09-13 14:21 ` [PATCH v3 05/14] dt-bindings: mfd: atmel,sama5d2-flexcom: Add SPI child node ref binding Sergiu Moga
2022-09-13 14:21 ` [PATCH v3 06/14] dt-bindings: serial: atmel,at91-usart: convert to json-schema Sergiu Moga
2022-09-13 14:28 ` Krzysztof Kozlowski
2022-09-13 14:21 ` [PATCH v3 07/14] dt-bindings: serial: atmel,at91-usart: Add SAM9260 compatibles to SAM9X60 Sergiu Moga
2022-09-13 14:28 ` Krzysztof Kozlowski
2022-09-13 14:22 ` [PATCH v3 08/14] dt-bindings: mfd: atmel,sama5d2-flexcom: Add USART child node ref binding Sergiu Moga
2022-09-13 14:29 ` Krzysztof Kozlowski
2022-09-13 14:22 ` [PATCH v3 09/14] dt-bindings: serial: atmel,at91-usart: Add gclk as a possible USART clock Sergiu Moga
2022-09-13 14:29 ` Krzysztof Kozlowski
2022-09-13 14:22 ` [PATCH v3 10/14] tty: serial: atmel: Define GCLK as USART baudrate source clock Sergiu Moga
2022-09-13 14:22 ` [PATCH v3 11/14] tty: serial: atmel: Define BRSRCCK bitmask of UART IP's Mode Register Sergiu Moga
2022-09-13 14:22 ` [PATCH v3 12/14] tty: serial: atmel: Only divide Clock Divisor if the IP is USART Sergiu Moga
2022-09-14 11:01 ` Ilpo Järvinen
2022-09-14 12:17 ` Sergiu.Moga
2022-09-13 14:22 ` [PATCH v3 13/14] clk: at91: sama5d2: Add Generic Clocks for UART/USART Sergiu Moga
2022-09-16 8:16 ` Claudiu.Beznea
2022-09-13 14:22 ` [PATCH v3 14/14] tty: serial: atmel: Make the driver aware of the existence of GCLK Sergiu Moga
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=53e72e5d-47fc-403d-c969-61b267a9ff15@microchip.com \
--to=claudiu.beznea@microchip.com \
--cc=Kavyasree.Kotagiri@microchip.com \
--cc=Nicolas.Ferre@microchip.com \
--cc=Sergiu.Moga@microchip.com \
--cc=Tudor.Ambarus@microchip.com \
--cc=admin@hifiphile.com \
--cc=alexandre.belloni@bootlin.com \
--cc=broonie@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=gregkh@linuxfoundation.org \
--cc=jirislaby@kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=lee@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-serial@vger.kernel.org \
--cc=linux-spi@vger.kernel.org \
--cc=mturquette@baylibre.com \
--cc=radu_nicolae.pirea@upb.ro \
--cc=richard.genoud@gmail.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).