Re: [PATCH v2 2/2] phy: ti-pipe3: Fix SATA across suspend/resume

[Roger Quadros <rogerq@ti.com>]

On 09/01/15 15:59, Kishon Vijay Abraham I wrote:
> Hi Roger,
> 
> On Thursday 08 January 2015 04:47 PM, Roger Quadros wrote:
>> Failed test case: Boot without SATA drive connected. Suspend/resume
>> the board and then connect SATA drive. It fails to enumerate.
>>
>> Due to Errata i783 "SATA Lockup After SATA DPLL Unlock/Relock"
>> we can't allow SATA DPLL to be in the unlocked state.
>> The SATA refclk (sata_ref_clk) is the source of the SATA_DPLL.
>> Till now this clock was controlled by the AHCI SATA driver and was being
>> shut off  during system suspend (if the SATA drive was not already attached)
>> causing the SATA DPLL to be unlocked and so causing errata i783.
>>
>> To prevent sata_ref_clk from being disabled, we move the control of
>> this clock from the SATA AHCI driver to the SATA PHY driver and prevent
>> it from being disabled.
>>
>> This also fixes the issue of SATA not working on OMAP5/DRA7 when
>> AHCI platform driver is built as a module.
> 
> I feel the dt patches and the PHY patches can go separately. Can you split and
> re-send?

OK. will re-send.

cheers,
-roger