Re: [PATCH 1/2] phy: usbphy: Add dt documentation for Broadcom Cygnus USB PHY driver

[Arun Ramamurthy <arun.ramamurthy@broadcom.com>]

Thank you for the review Arnd.
On 15-02-17 11:41 AM, Arnd Bergmann wrote:
> On Tuesday 17 February 2015 11:20:20 Arun Ramamurthy wrote:
>> +       /* This nodes declares  port 0
>> +       and port 1 as host*/
>> +
>> +       ehci0: usb@0x18048000 {
>> +               compatible = "generic-ehci";
>> +               reg = <0x18048000 0x100>;
>> +               interrupts = <GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>;
>> +               phys = <&usbphy0 0 1 &usbphy0 1>;
>
> The second reference in the example is missing the last cell,
> as you have #phy-cells = <2>.
>
I am missing a 1 for the port number, will update in next patchset, 
thank you
>> +               phy-names = "usbp0","usbp1";
>> +               status = "okay";
>> +       };
>
> Further, the binding for "generic-ehci" requires the name to be "usb",
> not "usbp0". You should probably update that binding if you can have
> multiple references to mention that.
>
> Can you make both names "usb"? If not, we should document a common
> naming scheme that the driver can use.
>
Arnd, I patched the ehci and ohci driver to accept multiple phys so they 
require different names and cannot both be "usb". That patch was 
accepted by Alen Stern but I did not update the bindings documentation.
I will send out another patch for that. Could we go with the naming 
scheme of "usb" + "p" + port number or do you have other suggestions?


> 	Arnd
>