From: Joshua Henderson <joshua.henderson-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
To: Rob Herring <robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
Cc: linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-mips-6z/3iImG2C8G8FEW9MqTrA@public.gmane.org,
Andrei Pistirica
<andrei.pistirica-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>,
Pawel Moll <pawel.moll-5wv7dgnIgG8@public.gmane.org>,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
Ian Campbell
<ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org>,
Kumar Gala <galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Subject: Re: [PATCH 12/14] DEVICETREE: Add bindings for PIC32 SDHC host controller
Date: Wed, 25 Nov 2015 22:16:32 -0700 [thread overview]
Message-ID: <565695B0.8090704@microchip.com> (raw)
In-Reply-To: <20151122215737.GA5285@rob-hp-laptop>
Hi Rob,
On 11/22/2015 2:57 PM, Rob Herring wrote:
> On Fri, Nov 20, 2015 at 05:17:24PM -0700, Joshua Henderson wrote:
>> From: Andrei Pistirica <andrei.pistirica-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
>>
>> Document the devicetree bindings for the SDHC peripheral found on
>> Microchip PIC32 class devices.
>>
>> Signed-off-by: Andrei Pistirica <andrei.pistirica-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
>> Signed-off-by: Joshua Henderson <joshua.henderson-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
>> ---
>> .../devicetree/bindings/mmc/sdhci-pic32.txt | 24 ++++++++++++++++++++
>> 1 file changed, 24 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-pic32.txt
>>
>> diff --git a/Documentation/devicetree/bindings/mmc/sdhci-pic32.txt b/Documentation/devicetree/bindings/mmc/sdhci-pic32.txt
>> new file mode 100644
>> index 0000000..f16388c
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/mmc/sdhci-pic32.txt
>> @@ -0,0 +1,24 @@
>> +* Microchip PIC32 SDHCI Controller
>> +
>> +This file documents differences between the core properties in mmc.txt
>> +and the properties used by the sdhci-pic32 driver.
>> +
>> +Required properties:
>> +- compatible: Should be "microchip,pic32-sdhci"
>> +- reg: Should contain registers location and length
>> +- interrupts: Should contain interrupt
>> +- pinctrl: Should contain pinctrl for data and command lines
>> +
>> +Optional properties:
>> +- no-1-8-v: 1.8V voltage selection not supported
>
> There's a standard property for this one.
>
Correct. This is indeed a standard property that should not be here. There is currently discussion to avoid using this property anyway.
>> +- piomode: disable DMA support
>
> Proably this one too IIRC.
>
We will be dropping this. There are other ways to accomplish the same thing outside of DT.
Josh
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2015-11-26 5:16 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-21 0:17 [PATCH 00/14] Initial Microchip PIC32MZDA Support Joshua Henderson
2015-11-21 0:17 ` [PATCH 01/14] DEVICETREE: Add bindings for PIC32 interrupt controller Joshua Henderson
2015-11-21 20:47 ` Arnd Bergmann
2015-11-25 18:22 ` Joshua Henderson
[not found] ` <1448065205-15762-2-git-send-email-joshua.henderson-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
2015-11-22 21:14 ` Rob Herring
2015-11-26 5:01 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 03/14] DEVICETREE: Add PIC32 clock binding documentation Joshua Henderson
2015-11-21 20:49 ` Arnd Bergmann
2015-11-26 4:05 ` Joshua Henderson
[not found] ` <1448065205-15762-4-git-send-email-joshua.henderson-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org>
2015-11-22 21:31 ` Rob Herring
2015-11-26 5:36 ` Joshua Henderson
2015-11-30 21:43 ` Rob Herring
2015-12-03 17:37 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 05/14] DEVICETREE: Add bindings for PIC32/MZDA platforms Joshua Henderson
2015-11-22 21:35 ` Rob Herring
2015-11-21 0:17 ` [PATCH 07/14] DEVICETREE: Add bindings for PIC32 pin control and GPIO Joshua Henderson
2015-11-22 21:47 ` Rob Herring
2015-12-04 13:02 ` Andrei.Pistirica
2015-12-08 22:13 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 09/14] DEVICETREE: Add bindings for PIC32 usart driver Joshua Henderson
2015-11-21 15:20 ` Sergei Shtylyov
2015-11-22 21:56 ` Rob Herring
2015-12-11 16:16 ` Joshua Henderson
2015-11-21 0:17 ` [PATCH 12/14] DEVICETREE: Add bindings for PIC32 SDHC host controller Joshua Henderson
2015-11-21 15:19 ` Sergei Shtylyov
2015-11-26 4:40 ` Joshua Henderson
2015-11-22 21:57 ` Rob Herring
2015-11-26 5:16 ` Joshua Henderson [this message]
2015-11-21 0:17 ` [PATCH 13/14] MIPS: dts: Add initial DTS for the PIC32MZDA Starter Kit Joshua Henderson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=565695B0.8090704@microchip.com \
--to=joshua.henderson-uwl1gki3jzl3ogb3hspcza@public.gmane.org \
--cc=andrei.pistirica-UWL1GkI3JZL3oGB3hsPCZA@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
--cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-mips-6z/3iImG2C8G8FEW9MqTrA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
--cc=robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).