Re: [PATCH v2 1/2] Documentation: afe4404: Add DT bindings for the AFE4404 heart monitor

[Jonathan Cameron <jic23-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>]

On 02/12/15 19:57, Andrew F. Davis wrote:
> Add the TI afe4404 heart monitor DT bindings documentation.
> Create health directory created under iio.
> 
> Signed-off-by: Andrew F. Davis <afd-l0cyMroinI0@public.gmane.org>
One little point inline - otherwise this is straightforward and
looks good to me.

Could add cross references to the interrupt and gpio docs.

Jonathan
> ---
>  .../devicetree/bindings/iio/health/afe4404.txt     | 27 ++++++++++++++++++++++
>  1 file changed, 27 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/health/afe4404.txt
> 
> diff --git a/Documentation/devicetree/bindings/iio/health/afe4404.txt b/Documentation/devicetree/bindings/iio/health/afe4404.txt
> new file mode 100644
> index 0000000..25b77a4
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/health/afe4404.txt
> @@ -0,0 +1,27 @@
> +* Texas Instruments AFE4404 Heart rate and Pulse Oximeter
> +
> +Required properties:
> + - compatible		: Should be "ti,afe4404".
> + - reg			: I2C address of the device.
> + - tx_sup-supply	: Regulator supply to LEDs.
If the sup bit is for supply I'd drop it and just have
tx-supply.
> + - interrupt-parent	: Phandle to he parent interrupt controller.
> + - interrupts		: The interrupt line the device ADC_RDY pin is connected to.
> +
> +Optional properties:
> + - reset-gpios		: GPIO used to reset the device.
> +
> +Example:
> +
> +&i2c2 {
> +	heart_mon@58 {
> +		compatible = "ti,afe4404";
> +		reg = <0x58>;
> +
> +		tx_sup-supply = <&vbat>;
> +
> +		interrupt-parent = <&gpio1>;
> +		interrupts = <28 IRQ_TYPE_EDGE_RISING>;
> +
> +		reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
> +	};
> +};
>