Re: [PATCH 06/11] drm: meson: add meson_dw_hdmi support for S4

[Krzysztof Kozlowski <krzk@kernel.org>]

On 10/01/2025 06:39, Ao Xu via B4 Relay wrote:
>  	/* Setup PHY */
> -	regmap_write(priv->hhi, HHI_HDMI_PHY_CNTL1, meson_dw_hdmi->data->cntl1_init);
> -	regmap_write(priv->hhi, HHI_HDMI_PHY_CNTL0, meson_dw_hdmi->data->cntl0_init);
> +	if (dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-s4-dw-hdmi")) {
> +		regmap_write(priv->hhi, ANACTRL_HDMIPHY_CTRL1,
> +			     meson_dw_hdmi->data->cntl1_init);
> +		regmap_write(priv->hhi, ANACTRL_HDMIPHY_CTRL0,
> +			     meson_dw_hdmi->data->cntl0_init);
> +	} else {
> +		regmap_write(priv->hhi, HHI_HDMI_PHY_CNTL1, meson_dw_hdmi->data->cntl1_init);
> +		regmap_write(priv->hhi, HHI_HDMI_PHY_CNTL0, meson_dw_hdmi->data->cntl0_init);
> +	}
>  
>  	/* Enable HDMI-TX Interrupt */
>  	meson_dw_hdmi->data->top_write(meson_dw_hdmi, HDMITX_TOP_INTR_STAT_CLR,
> @@ -766,10 +923,13 @@ static int meson_dw_hdmi_bind(struct device *dev, struct device *master,
>  	dw_plat_data->ycbcr_420_allowed = true;
>  	dw_plat_data->disable_cec = true;
>  	dw_plat_data->output_port = 1;
> +	if (dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-s4-dw-hdmi"))
> +		dw_plat_data->phy_force_vendor = 1;
>  
>  	if (dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-gxl-dw-hdmi") ||
>  	    dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-gxm-dw-hdmi") ||
> -	    dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-g12a-dw-hdmi"))
> +	    dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-g12a-dw-hdmi") ||
> +	    dw_hdmi_is_compatible(meson_dw_hdmi, "amlogic,meson-s4-dw-hdmi"))
>  		dw_plat_data->use_drm_infoframe = true;
>  
You should properly define driver/match data, instead of running
compatibility check 10 times in your driver.

This is unscalable and unmaintainable approach.

Best regards,
Krzysztof