* [PATCH] device-tree: nexus7-flo: Remove power gpio key entry and use pmic8xxx-pwrkey
@ 2016-04-13 17:16 John Stultz
2016-04-13 17:24 ` Sudeep Holla
0 siblings, 1 reply; 3+ messages in thread
From: John Stultz @ 2016-04-13 17:16 UTC (permalink / raw)
To: lkml
Cc: John Stultz, Rob Herring, Arnd Bergmann, Pawel Moll, Mark Rutland,
Ian Campbell, Kumar Gala, Andy Gross, Vinay Simha BN,
Bjorn Andersson, Stephen Boyd, linux-arm-msm, devicetree
Since the pmic8xxx-pwrkey driver is already supported in the
qcom-apq8064.dtsi, and the pmic8xxx-pwrkey supports logic to
configure proper device shutdown when ps_hold goes low, it is
better to use that driver then a generic gpio button.
Thus this patch remove the gpio power key entry here, so we
don't get double input events from having two drivers enabled.
The one gotcha with the pmic8xxx-pwrkey is it has a fairly
long debounce delay, which we shorten here to make the button
behave as expected.
Cc: Rob Herring <robh+dt@kernel.org>
Cc: Arnd Bergmann <arnd.bergmann@linaro.org>
Cc: Pawel Moll <pawel.moll@arm.com>
Cc: Mark Rutland <mark.rutland@arm.com>
Cc: Ian Campbell <ijc+devicetree@hellion.org.uk>
Cc: Kumar Gala <galak@codeaurora.org>
Cc: Andy Gross <agross@codeaurora.org>
Cc: Vinay Simha BN <simhavcs@gmail.com>
Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
Cc: Stephen Boyd <stephen.boyd@linaro.org>
Cc: linux-arm-msm@vger.kernel.org
Cc: devicetree@vger.kernel.org
Signed-off-by: John Stultz <john.stultz@linaro.org>
---
arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts | 15 +++++++++------
1 file changed, 9 insertions(+), 6 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
index c535b3f..7ac1c65 100644
--- a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
@@ -29,12 +29,6 @@
gpio-keys {
compatible = "gpio-keys";
- power {
- label = "Power";
- gpios = <&tlmm_pinmux 26 GPIO_ACTIVE_LOW>;
- linux,code = <KEY_POWER>;
- gpio-key,wakeup;
- };
volume_up {
label = "Volume Up";
gpios = <&pm8921_gpio 4 GPIO_ACTIVE_HIGH>;
@@ -190,6 +184,15 @@
};
};
+ /* override default debounce for power-key */
+ qcom,ssbi@500000 {
+ pmic@0 {
+ pwrkey@1c {
+ debounce = <1>;
+ };
+ };
+ };
+
gsbi@16200000 {
status = "okay";
qcom,mode = <GSBI_PROT_I2C>;
--
1.9.1
^ permalink raw reply related [flat|nested] 3+ messages in thread
* Re: [PATCH] device-tree: nexus7-flo: Remove power gpio key entry and use pmic8xxx-pwrkey
2016-04-13 17:16 [PATCH] device-tree: nexus7-flo: Remove power gpio key entry and use pmic8xxx-pwrkey John Stultz
@ 2016-04-13 17:24 ` Sudeep Holla
[not found] ` <570E80CA.3080100-5wv7dgnIgG8@public.gmane.org>
0 siblings, 1 reply; 3+ messages in thread
From: Sudeep Holla @ 2016-04-13 17:24 UTC (permalink / raw)
To: John Stultz, lkml
Cc: Sudeep Holla, Rob Herring, Arnd Bergmann, Pawel Moll,
Mark Rutland, Ian Campbell, Kumar Gala, Andy Gross,
Vinay Simha BN, Bjorn Andersson, Stephen Boyd, linux-arm-msm,
devicetree
On 13/04/16 18:16, John Stultz wrote:
> Since the pmic8xxx-pwrkey driver is already supported in the
> qcom-apq8064.dtsi, and the pmic8xxx-pwrkey supports logic to
> configure proper device shutdown when ps_hold goes low, it is
> better to use that driver then a generic gpio button.
>
> Thus this patch remove the gpio power key entry here, so we
> don't get double input events from having two drivers enabled.
>
> The one gotcha with the pmic8xxx-pwrkey is it has a fairly
> long debounce delay, which we shorten here to make the button
> behave as expected.
>
> Cc: Rob Herring <robh+dt@kernel.org>
> Cc: Arnd Bergmann <arnd.bergmann@linaro.org>
> Cc: Pawel Moll <pawel.moll@arm.com>
> Cc: Mark Rutland <mark.rutland@arm.com>
> Cc: Ian Campbell <ijc+devicetree@hellion.org.uk>
> Cc: Kumar Gala <galak@codeaurora.org>
> Cc: Andy Gross <agross@codeaurora.org>
> Cc: Vinay Simha BN <simhavcs@gmail.com>
> Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
> Cc: Stephen Boyd <stephen.boyd@linaro.org>
> Cc: linux-arm-msm@vger.kernel.org
> Cc: devicetree@vger.kernel.org
> Signed-off-by: John Stultz <john.stultz@linaro.org>
> ---
> arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts | 15 +++++++++------
> 1 file changed, 9 insertions(+), 6 deletions(-)
>
> diff --git a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
> index c535b3f..7ac1c65 100644
> --- a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
> +++ b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
> @@ -29,12 +29,6 @@
>
> gpio-keys {
> compatible = "gpio-keys";
> - power {
> - label = "Power";
> - gpios = <&tlmm_pinmux 26 GPIO_ACTIVE_LOW>;
> - linux,code = <KEY_POWER>;
> - gpio-key,wakeup;
You are dropping wakeup with this change. Is that intentional ?
If not, while you are at this, replace it with "wakeup-source"
which is standard binding.
If yes, then it solves the problem :). I had a patch to replace it, but
was waiting to check if any new files in linux-next before posting. For
now, this is the only legacy entry.
--
Regards,
Sudeep
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: [PATCH] device-tree: nexus7-flo: Remove power gpio key entry and use pmic8xxx-pwrkey
[not found] ` <570E80CA.3080100-5wv7dgnIgG8@public.gmane.org>
@ 2016-04-13 17:34 ` John Stultz
0 siblings, 0 replies; 3+ messages in thread
From: John Stultz @ 2016-04-13 17:34 UTC (permalink / raw)
To: Sudeep Holla
Cc: lkml, Rob Herring, Arnd Bergmann, Pawel Moll, Mark Rutland,
Ian Campbell, Kumar Gala, Andy Gross, Vinay Simha BN,
Bjorn Andersson, Stephen Boyd,
linux-arm-msm-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA
On Wed, Apr 13, 2016 at 10:24 AM, Sudeep Holla <sudeep.holla-5wv7dgnIgG8@public.gmane.org> wrote:
>
>
> On 13/04/16 18:16, John Stultz wrote:
>>
>> Since the pmic8xxx-pwrkey driver is already supported in the
>> qcom-apq8064.dtsi, and the pmic8xxx-pwrkey supports logic to
>> configure proper device shutdown when ps_hold goes low, it is
>> better to use that driver then a generic gpio button.
>>
>> Thus this patch remove the gpio power key entry here, so we
>> don't get double input events from having two drivers enabled.
>>
>> The one gotcha with the pmic8xxx-pwrkey is it has a fairly
>> long debounce delay, which we shorten here to make the button
>> behave as expected.
>>
>> Cc: Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
>> Cc: Arnd Bergmann <arnd.bergmann-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
>> Cc: Pawel Moll <pawel.moll-5wv7dgnIgG8@public.gmane.org>
>> Cc: Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>
>> Cc: Ian Campbell <ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org>
>> Cc: Kumar Gala <galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
>> Cc: Andy Gross <agross-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
>> Cc: Vinay Simha BN <simhavcs-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
>> Cc: Bjorn Andersson <bjorn.andersson-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
>> Cc: Stephen Boyd <stephen.boyd-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
>> Cc: linux-arm-msm-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
>> Cc: devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
>> Signed-off-by: John Stultz <john.stultz-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
>> ---
>> arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts | 15 +++++++++------
>> 1 file changed, 9 insertions(+), 6 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
>> b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
>> index c535b3f..7ac1c65 100644
>> --- a/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
>> +++ b/arch/arm/boot/dts/qcom-apq8064-asus-nexus7-flo.dts
>> @@ -29,12 +29,6 @@
>>
>> gpio-keys {
>> compatible = "gpio-keys";
>> - power {
>> - label = "Power";
>> - gpios = <&tlmm_pinmux 26 GPIO_ACTIVE_LOW>;
>> - linux,code = <KEY_POWER>;
>> - gpio-key,wakeup;
>
>
> You are dropping wakeup with this change. Is that intentional ?
>
> If not, while you are at this, replace it with "wakeup-source"
> which is standard binding.
Thanks for catching this. Its not intentional, but I don't have
suspend/resume working yet on the n7 so I've never really tested it.
I'll add wakeup-source to the pwrkey entry for the next version.
thanks
-john
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2016-04-13 17:34 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2016-04-13 17:16 [PATCH] device-tree: nexus7-flo: Remove power gpio key entry and use pmic8xxx-pwrkey John Stultz
2016-04-13 17:24 ` Sudeep Holla
[not found] ` <570E80CA.3080100-5wv7dgnIgG8@public.gmane.org>
2016-04-13 17:34 ` John Stultz
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).