Re: [PATCH 4/5] arm64: dts: qcom: x1e80100-crd: Fix backlight

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 10.07.2024 7:05 PM, Stephan Gerhold wrote:
> The backlight does not work correctly with the current display panel
> configuration: It works after boot, but once the display gets disabled it
> is not possible to get it back on. It turns out that the ATNA45AF01 panel
> needs exactly the same non-standard power sequence as implemented by the
> panel-samsung-atna33xc20 driver for sc7180-trogdor-homestar.
> 
> Switch the panel in the DT to the new compatible and make two more changes
> to make it work correctly:
> 
>  1. Add the missing GPIO for the panel EL_ON3 line (EDP_BL_EN on CRD and
>     enable-gpios in the DT).
>  2. Drop the regulator-always-on for the panel regulator. The panel does
>     not seem to power off properly if the regulator stays on.
> 
> Signed-off-by: Stephan Gerhold <stephan.gerhold@linaro.org>
> ---

[...]

> +		power-source = <1>; /* 1.8V */

Would be nice to get the #defines for this PMIC instead..

> +		input-disable;
> +		output-enable;

LGTM otherwise

Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>

Konrad