From mboxrd@z Thu Jan 1 00:00:00 1970 From: Roman Byshko Subject: [PATCH 1/5] phy: sun4i: add support for USB phy0 Date: Mon, 27 Oct 2014 22:43:01 +0100 Message-ID: <668c1b5541fc0175957573bd5f8d40dd2eaccae1.1414444953.git.rbyshko@gmail.com> References: Return-path: In-Reply-To: In-Reply-To: References: Sender: linux-kernel-owner@vger.kernel.org To: linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, devicetree@vger.kernel.org Cc: Kishon Vijay Abraham I , Maxime Ripard , Russell King , Kumar Gala , Ian Campbell , Mark Rutland , Pawel Moll , Rob Herring List-Id: devicetree@vger.kernel.org The driver for sun4i USB phys currently supports only phy1 and phy2 which are used for USB host controllers. This patch adds support for USB phy0, which is used by the musb hdrc USB controller. --- drivers/phy/phy-sun4i-usb.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i-usb.c index 0baf5ef..a24728b 100644 --- a/drivers/phy/phy-sun4i-usb.c +++ b/drivers/phy/phy-sun4i-usb.c @@ -157,6 +157,10 @@ static int sun4i_usb_phy_init(struct phy *_phy) return ret; } + /* Regulation 45 ohms */ + if (phy->index == 0) + sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1); + /* Adjust PHY's magnitude and rate */ sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5); @@ -213,7 +217,7 @@ static struct phy *sun4i_usb_phy_xlate(struct device *dev, { struct sun4i_usb_phy_data *data = dev_get_drvdata(dev); - if (WARN_ON(args->args[0] == 0 || args->args[0] >= data->num_phys)) + if (args->args[0] >= data->num_phys) return ERR_PTR(-ENODEV); return data->phys[args->args[0]].phy; @@ -255,8 +259,7 @@ static int sun4i_usb_phy_probe(struct platform_device *pdev) if (IS_ERR(data->base)) return PTR_ERR(data->base); - /* Skip 0, 0 is the phy for otg which is not yet supported. */ - for (i = 1; i < data->num_phys; i++) { + for (i = 0; i < data->num_phys; i++) { struct sun4i_usb_phy *phy = data->phys + i; char name[16]; -- 2.1.2