Re: [PATCH v3 3/6] iio: adc: ad7173: refactor ain and vref selection

["Nuno Sá" <noname.nuno@gmail.com>]

On Mon, 2024-05-27 at 20:02 +0300, Dumitru Ceclan via B4 Relay wrote:
> From: Dumitru Ceclan <dumitru.ceclan@analog.com>
> 
> Move validation of analog inputs and reference voltage selection to
> separate functions to reduce the size of the channel config parsing
> function and improve readability.
> 
> Reviewed-by: David Lechner <dlechner@baylibre.com>
> Signed-off-by: Dumitru Ceclan <dumitru.ceclan@analog.com>
> ---
>  drivers/iio/adc/ad7173.c | 62 ++++++++++++++++++++++++++++++++++--------------
>  1 file changed, 44 insertions(+), 18 deletions(-)
> 
> diff --git a/drivers/iio/adc/ad7173.c b/drivers/iio/adc/ad7173.c
> index 9e507e2c66f0..8a53821c8e58 100644
> --- a/drivers/iio/adc/ad7173.c
> +++ b/drivers/iio/adc/ad7173.c
> @@ -906,6 +906,44 @@ static int ad7173_register_clk_provider(struct iio_dev
> *indio_dev)
>  					   &st->int_clk_hw);
>  }
>  
> +static int ad7173_validate_voltage_ain_inputs(struct ad7173_state *st,
> +					      unsigned int ain[2])
> +{
> +	struct device *dev = &st->sd.spi->dev;
> +
> +	for (int i = 0; i < 2; i++) {
> +		if (ain[i] < st->info->num_inputs)
> +			continue;
> +
> +		return dev_err_probe(dev, -EINVAL,
> +			"Input pin number out of range for pair (%d %d).\n",
> +			ain[0], ain[1]);
> +	}
> +
> +	return 0;
> +}
> +
> +static int ad7173_validate_reference(struct ad7173_state *st, int ref_sel)
> +{
> +	struct device *dev = &st->sd.spi->dev;
> +	int ret;
> +
> +	if (ref_sel == AD7173_SETUP_REF_SEL_INT_REF && !st->info->has_int_ref)
> +		return dev_err_probe(dev, -EINVAL,
> +			"Internal reference is not available on current
> model.\n");
> +
> +	if (ref_sel == AD7173_SETUP_REF_SEL_EXT_REF2 && !st->info->has_ref2)
> +		return dev_err_probe(dev, -EINVAL,
> +			"External reference 2 is not available on current
> model.\n");
> +
> +	ret = ad7173_get_ref_voltage_milli(st, ref_sel);
> +	if (ret < 0)
> +		return dev_err_probe(dev, ret, "Cannot use reference %u\n",
> +				     ref_sel);
> +
> +	return 0;

If you need a v4, I would just 'return ad7173_get_ref_voltage_milli(...)'. Any error
log needed should be done inside ad7173_get_ref_voltage_milli(). Anyways:

Reviewed-by: Nuno Sa <nuno.sa@analog.com>

- Nuno Sá