Re: [PATCH v3 1/5] clk: samsung: clk-pll: Implement pll0822x PLL type

[Sylwester Nawrocki <snawrocki@kernel.org>]

On 08.10.2021 17:43, Sam Protsenko wrote:
> pll0822x PLL is used in Exynos850 SoC for top-level integer PLLs. The
> code was derived from very similar pll35xx type, with next differences:
> 
> 1. Lock time for pll0822x is 150*P_DIV, when for pll35xx it's 270*P_DIV
> 2. It's not suggested in Exynos850 TRM that S_DIV change doesn't require
>     performing PLL lock procedure (which is done in pll35xx
>     implementation)
> 
> When defining pll0822x type, CON3 register offset should be provided as
> a "con" parameter of PLL() macro, like this:
> 
>      PLL(pll_0822x, 0, "fout_shared0_pll", "oscclk",
>          PLL_LOCKTIME_PLL_SHARED0, PLL_CON3_PLL_SHARED0,
>          exynos850_shared0_pll_rates),
> 
> To define PLL rates table, one can use PLL_35XX_RATE() macro, e.g.:
> 
>      PLL_35XX_RATE(26 * MHZ, 1600 * MHZ, 800, 13, 0)
> 
> as it's completely appropriate for pl0822x type and there is no sense in
> duplicating that.
> 
> If bit #1 (MANUAL_PLL_CTRL) is not set in CON1 register, it won't be
> possible to set new rate, with next error showing in kernel log:
> 
>      Could not lock PLL fout_shared1_pll
> 
> That can happen for example if bootloader clears that bit beforehand.
> PLL driver doesn't account for that, so if MANUAL_PLL_CTRL bit was
> cleared, it's assumed it was done for a reason and it shouldn't be
> possible to change that PLL's rate at all.
> 
> Signed-off-by: Sam Protsenko<semen.protsenko@linaro.org>
> Reviewed-by: Krzysztof Kozlowski<krzysztof.kozlowski@canonical.com>
> Acked-by: Chanwoo Choi<cw00.choi@samsung.com>

Applied, thanks.