Re: [PATCH 9/9] dt-bindings: net: ipq4019-mdio: Document ipq5332 platform

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 17/11/2023 12:20, Jie Luo wrote:
> 
> 
> On 11/17/2023 6:40 PM, Krzysztof Kozlowski wrote:
>> On 17/11/2023 11:36, Jie Luo wrote:
>>>>>      clocks:
>>>>> -    items:
>>>>> -      - description: MDIO clock source frequency fixed to 100MHZ
>>>>> +    minItems: 1
>>>>> +    maxItems: 5
>>>>> +    description:
>>>>
>>>> Doesn't this make all other variants with incorrect constraints?
>>>
>>> There are 5 clock items, the first one is the legacy MDIO clock, the
>>> other clocks are new added for ipq5332 platform, will describe it more
>>> clearly in the next patch set.
>>
>> OTHER variants. Not this one.
> 
> The change here is for the clock number added for the ipq5332 platform,
> the other platforms still use only legacy MDIO clock.

Then your patch is wrong as I said. You now affect other variants. I
don't quite get your responses. Style of them suggests that you
disagree, but you are not providing any relevant argument.

> 
> so i add minItems  and maxItems, i will check other .yaml files for the
> reference.
> 
>>
>>>
>>>>
>>>>> +      MDIO system clock frequency fixed to 100MHZ, and the GCC uniphy
>>>>> +      clocks enabled for resetting ethernet PHY.
>>>>>    
>>>>>      clock-names:
>>>>> -    items:
>>>>> -      - const: gcc_mdio_ahb_clk
>>>>> +    minItems: 1
>>>>> +    maxItems: 5
>>>>> +
>>>>> +  phy-reset-gpio:
>>>>
>>>> No, for multiple reasons. It's gpios first of all. Where do you see such
>>>> property? Where is the existing definition?
>>>
>>> will remove this property, and update to use the exited PHY GPIO reset.
>>>
>>>>
>>>> Then it is "reset-gpios" if this is MDIO. Why do you put phy properties
>>>> in MDIO?
>>>>
>>>>> +    minItems: 1
>>>>> +    maxItems: 3
>>>>> +    description:
>>>>> +      GPIO used to reset the PHY, each GPIO is for resetting the connected
>>>>> +      ethernet PHY device.
>>>>> +
>>>>> +  phyaddr-fixup:
>>>>> +    description: Register address for programing MDIO address of PHY devices
>>>>
>>>> You did not test code which you sent.
>>>
>>> Hi Krzysztof,
>>> This patch is passed with the following command in my workspace.
>>> i will upgrade and install yamllint to make sure there is no
>>> warning reported anymore.
>>>
>>> make dt_bg_check
>>
>> No clue what's this, but no, I do not believe you tested it at all. It's
>> not about yamllint. It's was not tested. Look at errors reported on
>> mailing list.
>>
>>> DT_SCHEMA_FILES=Documentation/devicetree/bindings/net/qcom,ipq4019-mdio.yaml
>>
> 
> Hi Krzysztof,
> Here is the output when i run the dt check with this patch applied in my 
> workspace, md64 is the alias for compiling the arm64 platform.

We still do not know your base and dtschema version.


Best regards,
Krzysztof