Re: [PATCH v2 1/3] ARM: dts: imx6: phytec: fix RTC interrupt level

["Stefan Riedmüller" <S.Riedmueller@phytec.de>]

Hi Andrej,

On Wed, 2023-07-19 at 13:43 +0200, Andrej Picej wrote:
> RTC interrupt level should be set to "LOW". This was revealed by the
> introduction of commit:
> 
>   f181987ef477 ("rtc: m41t80: use IRQ flags obtained from fwnode")
> 
> which changed the way IRQ type is obtained.
> 
> Signed-off-by: Andrej Picej <andrej.picej@norik.com>

Reviewed-by: Stefan Riedmüller <s.riedmueller@phytec.de>

> ---
> Changes in v2:
>  - no changes
> ---
>  arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
> b/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
> index 1a599c294ab8..1ca4d219609f 100644
> --- a/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
> +++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
> @@ -182,7 +182,7 @@ i2c_rtc: rtc@68 {
>                 pinctrl-0 = <&pinctrl_rtc_int>;
>                 reg = <0x68>;
>                 interrupt-parent = <&gpio7>;
> -               interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
> +               interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
>                 status = "disabled";
>         };
>  };