Re: [PATCH RFC v4 10/12] reset: zte: Add a zx297520v3 reset driver

["Stefan Dösinger" <stefandoesinger@gmail.com>]

[-- Attachment #1: Type: text/plain, Size: 1165 bytes --]

Hi Philipp,

Am Donnerstag, 18. Juni 2026, 12:24:26 Ostafrikanische Zeit schrieb Philipp 
Zabel:

> > +	[ZX297520V3_UART0_RESET]     = { .reg = 0x78,  .mask = BIT(6)  | 
BIT(7) 
> > },
> Is this a single reset line controlled by two bits (do you know what
> they are)? Or might these actually be two different reset controls that
> are just always set together?

I suppose I could expose both bits as separate reset controls in the binding. 
The lower bit is usually the one that actually resets the device, while the 
higher one works similarly to PCLK - it disconnects the device from the bus, 
if asserted. Depending on the device it may or may not leave any residual 
effect behind after deassert.

The stumbling block is the dwc2 USB driver. It only takes one reset, so I'd 
have to add another one (or abuse the dwc2-ecc reset) and presumably add a PHY 
driver for the 3rd reset or add a dwc2-phy reset.

The AMBA bus already takes an array of resets, so the pl011 UARTs are fine 
either way. For stmmac I need a glue driver for other reasons anyway. the 
dwc,mmc2 controller on this board seems to have only one reset, so no need to 
extend the driver here.

[-- Attachment #2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 870 bytes --]