Re: [PATCH 15/15] ARM: dts: qcom: Add initial device tree for Kuno SoC

[Hardeep Sharma <hardeep.sharma@oss.qualcomm.com>]

On 8/13/2026 9:31 PM, Dmitry Baryshkov wrote:
> On Thu, Aug 13, 2026 at 11:44:28AM +0200, Krzysztof Kozlowski wrote:
>> On Tue, Aug 11, 2026 at 04:13:40AM +0300, Dmitry Baryshkov wrote:
>>> On Sun, Aug 09, 2026 at 12:57:14PM +0530, Hardeep Sharma wrote:
>>>> Add SoC-level DTSI (qcom-kuno.dtsi) and IDP board DTS
>>>> (qcom-kuno-idp.dts) for the Qualcomm Kuno SoC.
>>>>
>>>> Peripherals included in this initial set:
>>>>    - Single Cortex-A7 CPU with PSCI idle states
>>>>    - RPMh RSC with clock controller, power domains, and BCM voter
>>>>    - GCC (Global Clock Controller)
>>>>    - TLMM pin controller (110 GPIOs)
>>>>    - Interconnect (aggre-noc, cnoc-main)
>>>>    - GENI UART console (QUP SE3)
>>>>    - SMEM, hardware spinlocks (TCSR mutex)
>>> This is pretty limited without any storage. Does it NAND?
>> It has serial connection. this is enough for a start. At least one
>> communication interface is needed for early upstreaming.
> Yes, but then, as I wrote, it is pretty useless without the backing
> storage. Also, it would be nice if we new the future plan. Is it going
> to stop at this point? Is it going to be expanded in the next few weeks?
> Will we see a spread of conflicting patches 'arm64: qcom: kuno: add
> support for foo' with foo in 'USB, PCI, remoteproc, NAND, etc.'.

Hi Dmitry

Thanks for review.

Kuno is 32-bit ARM (Cortex-A7), so follow-ups will be `ARM: qcom:
kuno:`, not `arm64:`.

This series is the minimum-viable base (console + core infra),
following the sdx55/sdx75 pattern. Storage and the other drivers will
follow in coordinated series on top of this base.

Best wishes,
Hardeep Sharma