Re: [PATCH v2 3/6] arm64: dts: qcom: r0q: add touchscreen support

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 10/17/25 8:22 PM, Eric Gonçalves wrote:
> 
> 
> On October 17, 2025 5:20:43 AM GMT-03:00, Konrad Dybcio <konrad.dybcio@oss.qualcomm.com> wrote:
>> On 10/16/25 10:08 PM, Ghatto wrote:
>>> On Thu, Oct 16, 2025 at 6:06 AM Konrad Dybcio
>>> <konrad.dybcio@oss.qualcomm.com> wrote:
>>>>
>>>>
>>>>
>>>> On 10/14/25 9:04 PM, Ghatto wrote:
>>>>> On Tue, Oct 14, 2025 at 11:18 AM Konrad Dybcio
>>>>> <konrad.dybcio@oss.qualcomm.com> wrote:
>>>>>>
>>>>>> On 10/14/25 5:10 PM, Ghatto wrote:
>>>>>>> On Tue, Oct 14, 2025 at 7:01 AM Konrad Dybcio
>>>>>>> <konrad.dybcio@oss.qualcomm.com> wrote:
>>>>>>>>
>>>>>>>> On 10/14/25 6:41 AM, Eric Gonçalves wrote:
>>>>>>>>> Enable the ST-Microelectronics FTS2BA61Y touchscreen. This patch
>>>>>>>>> depends on "Input: add support for the STM FTS2BA61Y touchscreen".
>>>>>>>>
>>>>>>>> The second sentence doesn't really make sense to be included in
>>>>>>>> the git log
>>>>>>> I'll keep it to the cover letter then
>>>>>>>>
>>>>>>>>> The device has an issue where SPI 8 (the bus which the touchscreen is
>>>>>>>>> connected to) is not working properly right now, so
>>>>>>>>> spi-gpio is used instead.
>>>>>>>>
>>>>>>>> Some Samsung devices used to use spi/i2c-gpio intentionally, also
>>>>>>>> on downstream. I'm assuming this isn't the case for r0q.
>>>>>>> It isn't, the device uses fts2ba61y on the spi8 bus - I hosted the
>>>>>>> DT at https://github.com/ghatt-o/ss_experiments/blob/main/r0q.dts if you
>>>>>>> want to take a look.
>>>>>>>>
>>>>>>>> Did you enable gpi_dma1, qupv3_id_1 before spi8, when testing
>>>>>>> The driver probes, but it fails to recognize the touchscreen device
>>>>>>
>>>>>> Could you post a complete dmesg and the precise DT diff you used?
>>>>> https://pastebin.com/QkYa8nMp (android dmesg) mainline dmesg doesn't have
>>>>
>>>> The link has expired 🙁
>>> https://pastebin.com/s4abJS9M shouldn't expire now!
>>
>> And yet it did!
>>
>> Feel free to just attach it to your message.. the list may bounce
>> it, but it will still reach the To/Cc recipients
> Attached the dmesg.txt file.

I'm interested in what happens early when the SPI hosts are programmed,
whether there's any additional debug messages.

If your log buffer is overrunning, you can add log_buf_len=8M to your
cmdline (which will make the buffer 8MiB long)

Konrad