Re: [PATCH 07/18] spi: qup: Fix transaction done signaling

[Sricharan R <sricharan-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>]

Hi Andy,

On 6/15/2017 1:21 AM, Andy Gross wrote:
> On Wed, Jun 14, 2017 at 12:43:43PM +0530, Sricharan R wrote:
>> Hi Varada,
>>
>> On 6/14/2017 11:22 AM, Varadarajan Narayanan wrote:
>>> Wait to signal done until we get all of the interrupts we are expecting
>>> to get for a transaction.  If we don't wait for the input done flag, we
>>> can be inbetween transactions when the done flag comes in and this can
>>> mess up the next transaction.
>>>
>>> Signed-off-by: Andy Gross <andy.gross-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
>>> Signed-off-by: Varadarajan Narayanan <varada-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
>>> ---
>>>  drivers/spi/spi-qup.c | 3 ++-
>>>  1 file changed, 2 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/spi/spi-qup.c b/drivers/spi/spi-qup.c
>>> index 2124815..7c22ee4 100644
>>> --- a/drivers/spi/spi-qup.c
>>> +++ b/drivers/spi/spi-qup.c
>>> @@ -465,7 +465,8 @@ static irqreturn_t spi_qup_qup_irq(int irq, void *dev_id)
>>>  	controller->xfer = xfer;
>>>  	spin_unlock_irqrestore(&controller->lock, flags);
>>>  
>>> -	if (controller->rx_bytes == xfer->len || error)
>>> +	if ((controller->rx_bytes == xfer->len &&
>>> +		(opflags & QUP_OP_MAX_INPUT_DONE_FLAG)) ||  error)
>>
>>  Not sure why we need this additional check, because having read all the
>>  bytes implies transfer complete (or) why not just check only for
>>  QUP_OP_MAX_INPUT_DONE_FLAG ?
> 
> So you can receive an interrupt for the last data without it having also
> signalled the INPUT_DONE.  That means you'd have one more IRQ come in and if you
> don't wait for that, you could start up the next transaction and have an irq
> come in that screws up that transaction.
> 
> It might be sufficient to just wait for the INPUT_DONE_FLAG.  That cannot be
> signalled unless the rx_bytes == xfer->len.
> 

 Right, that should simply it little bit.

Regards,
 Sricharan

-- 
"QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html