Re: [PATCH v4 0/5] Add initial Milk-V Duo S board support

[Michael Opdenacker <michael.opdenacker@rootcommit.com>]

Hi Joshua

On 4/2/26 2:29 PM, Joshua Milas wrote:
> Hi Michael,
>
> Thanks for testing this. I am not seeing that issue on my arm64 or riscv side.
> I am able to add an IP and do anything I can think of on the arm64 side.
>
> [   96.618687] stmmaceth 4070000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
> [   96.633977] stmmaceth 4070000.ethernet eth0: PHY [mdio_mux-0.0:01] driver [Generic PHY] (irq=POLL)
> [   96.676436] dwmac1000: Master AXI performs any burst length
> [   96.702852] stmmaceth 4070000.ethernet eth0: No Safety Features support found
> [   96.748740] stmmaceth 4070000.ethernet eth0: IEEE 1588-2002 Timestamp supported
> [   96.772880] stmmaceth 4070000.ethernet eth0: configuring for phy/internal link mode
> [ 1359.377528] stmmaceth 4070000.ethernet eth0: Link is Up - 100Mbps/Full - flow control off
>
> I can do the same on the riscv side but get a unhandled signal for TLS traffic
> which I believe is unrelated as it doesn't happen on adding an IP.
>
> I'll send over my configs to see if that helps.

I confirmed I managed to test the eth0 network interface on the riscv 
side using the configuration you shared. It would take me more time to 
test on arm64 :D|
You can send a update with your checkpatch fixes.

Tested-by: Michael Opdenacker <michael.opdenacker@rootcommit.com>

Thanks for everything!
Cheers
Michael.

-- 
Root Commit
Embedded Linux Training and Consulting
https://rootcommit.com