Devicetree
 help / color / mirror / Atom feed
 messages from 2026-06-25 22:17:27 to 2026-06-26 04:16:24 UTC [more...]

[RFC PATCH 0/2] Add Lenovo ThinkEdge SE70 carrier board support
 2026-06-26  1:23 UTC  (4+ messages)
` [PATCH 1/2] dt-bindings: arm: tegra: Add lenovo,thinkedge-se70 compatible string
` [PATCH 2/2] arm64: tegra: Add Lenovo ThinkEdge SE70 carrier board DTS

[PATCH] arm64: dts: qcom: eliza: Add PCIe PHY and controller nodes
 2026-06-26  4:16 UTC  (3+ messages)

[PATCH v6 0/8] clk: qcom: Add common clkref support and migrate Glymur and Mahua
 2026-06-26  3:53 UTC  (6+ messages)
` [PATCH v6 5/8] clk: qcom: tcsrcc-glymur: Add Mahua QREF regulator support

[RFC v2 PATCH 0/2] Add Lenovo ThinkEdge SE70 carrier board support
 2026-06-26  3:47 UTC  (5+ messages)
` [PATCH 1/2] dt-bindings: arm: tegra: Add lenovo,thinkedge-se70 compatible string
` [PATCH 2/2] arm64: tegra: Add Lenovo ThinkEdge SE70 carrier board DTS

[PATCH v2 0/2] rtq2208: Remove the unnecessary MTP_SEL property
 2026-06-26  3:46 UTC  (4+ messages)
` [PATCH v2 1/2] regulator: dt-bindings: rtq2208: Label mtp-sel-high property as deprecated
` [PATCH v2 2/2] regualtor: rtq2208: Initiate the default MTP_SEL state by hardware register

[PATCH v3 0/9] ASoC: Add Loongson-2K0300 I2S controller and sound card support
 2026-06-26  2:44 UTC  (17+ messages)
` [PATCH v3 1/9] ASoC: loongson: Fix error handling in ACPI property parsing
` [PATCH v3 2/9] ASoC: dt-bindings: loongson,ls2k1000-i2s: Document Loongson-2K0300 compatible
` [PATCH v3 3/9] ASoC: loongson: Add Loongson-2K0300 I2S controller support
` [PATCH v3 4/9] ASoC: dt-bindings: loongson,ls-audio-card: Use common sound card
` [PATCH v3 5/9] ASoC: dt-bindings: loongson,ls-audio-card: Add ctcisz forever pi compatible
` [PATCH v3 6/9] ASoC: loongson: Add Loongson-2K0300 CTCISZ Forever Pi sound card support
` [PATCH v3 7/9] ASoC: dt-bindings: loongson,ls-audio-card: Add ATK-DL2K0300B compatible
` [PATCH v3 8/9] ASoC: loongson: Add headphone jack detection and DAPM routing
` [PATCH v3 9/9] ASoC: es8328: Add DAPM routes from MIC inputs to Mic Bias

[PATCH V3 0/8] Add PCIe M.2 Key E connector support for NXP i.MX boards
 2026-06-26  2:31 UTC  (9+ messages)
` [PATCH V3 1/8] PCI: imx6: Add skip_pwrctrl_off flag support
` [PATCH V3 2/8] power: sequencing: pcie-m2: Add PCI ID for NXP 88W9098 and AW693 Bluetooth
` [PATCH V3 3/8] Bluetooth: btnxpuart: Add M.2 Bluetooth device support using pwrseq
` [PATCH V3 4/8] arm64: dts: imx8mq-evk: Describe the PCIe M.2 Key E connector
` [PATCH V3 5/8] arm64: dts: imx95-19x19-evk: "
` [PATCH V3 6/8] arm64: dts: imx8dxl-evk: "
` [PATCH V3 7/8] arm64: dts: imx8qm-mek: "
` [PATCH V3 8/8] arm64: dts: imx8qxp-mek: "

[PATCH v6 0/2] Add Lontium LT9611C(EX/UXD) MIPI DSI to HDMI driver
 2026-06-26  2:15 UTC  (11+ messages)
` [PATCH v6 2/2] drm/bridge: "

[PATCH v2 0/2] Fix traceNoC probe issue on Kaanapali
 2026-06-26  2:03 UTC  (10+ messages)
` [PATCH v2 2/2] arm64: dts: qcom: kaanapali: fix traceNoC probe issue

[PATCH v7 00/13] drm: renesas: rz-du: Add RZ/G3E support
 2026-06-26  0:59 UTC  (5+ messages)
` [PATCH v7 02/13] dt-bindings: display: renesas,rzg2l-du: Add support for RZ/G3E SoC

[PATCH 0/4] PCI: mediatek-gen3: Add 2-lanes mode support + clock
 2026-06-26  0:20 UTC  (3+ messages)
` [PATCH 2/4] clk: en7523: add support for dedicated PCIe PERSTOUT reset

[PATCH RFC 0/4] media: i2c: Add Samsung S5K3L6 and Librem 5 rear camera
 2026-06-26  0:07 UTC  (5+ messages)
` [PATCH RFC 1/4] media: imx8mq-mipi-csi2: Make reset release SoC-specific
` [PATCH RFC 2/4] dt-bindings: media: i2c: Add Samsung S5K3L6 image sensor
` [PATCH RFC 3/4] media: i2c: Add Samsung S5K3L6 image sensor driver
` [PATCH RFC 4/4] arm64: dts: imx8mq-librem5: Add rear camera

[PATCH v6 0/2] input: misc: add support for Imagis ISA1200 haptic motor driver
 2026-06-25 23:45 UTC  (3+ messages)
` [PATCH v6 2/2] Input: isa1200 - new driver for Imagis ISA1200

[PATCH v14 0/5] Enable Remote GPIO over RPMSG on i.MX Platform
 2026-06-25 22:17 UTC  (3+ messages)
` [PATCH v14 4/5] gpio: rpmsg: add generic rpmsg GPIO driver


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox