messages from 2026-10-15 10:49:51 to 2026-10-15 11:44:13 UTC [more...]
[PATCH v2] arm64: dts: st: add thermal zones on stm32mp251
2026-10-15 11:43 UTC (2+ messages)
[PATCH v8 0/8] Read MAC address from SST vendor specific SFDP region
2026-10-15 11:42 UTC (7+ messages)
` [PATCH v8 3/8] nvmem: core: take a reference on dev.of_node in nvmem_register()
` [PATCH v8 5/8] nvmem: layouts: add Microchip/SST SFDP EUI layout driver
[PATCH v3 0/2] Input: add support for OnePlus/OPPO Pad pogo-pin keyboards
2026-10-15 11:19 UTC (5+ messages)
` [PATCH v4 "
` [PATCH v4 1/2] dt-bindings: input: add OnePlus pogo-pin keyboard
` [PATCH v4 2/2] Input: add OnePlus/OPPO Pad pogo-pin keyboard serdev driver
[PATCH] arm64: dts: qcom: shikra: Drop CPU critical trips
2026-10-15 11:13 UTC (4+ messages)
[PATCH v1 1/1] arm64: dts: imx8mn-evk: Pass GPIO_OPEN_DRAIN flag on i2c3 GPIOs
2026-10-15 11:12 UTC (3+ messages)
[PATCH v5 0/7] Speakers for Pixel 3 / 3 XL
2026-10-15 11:12 UTC (5+ messages)
` [PATCH v5 6/7] arm64: dts: qcom: sdm845-google: Add basic audio support
` [PATCH v5 7/7] arm64: dts: qcom: sdm845-google: Add WCD9340 codec and microphone capture
[PATCH v2 1/2] dt-bindings: input: add OnePlus pogo-pin keyboard
2026-10-15 11:08 UTC (2+ messages)
[PATCH v10 0/8] gpio: add Ambarella CV75 PL061 support
2026-10-15 11:08 UTC (12+ messages)
` [PATCH v10 1/8] dt-bindings: gpio: pl061: add Ambarella CV75 variant
` [PATCH v10 2/8] gpiolib: regmap: add GPIO_REGMAP_QUIRK_SET_AFTER_DIR
` [PATCH v10 3/8] gpio: pl061: drop redundant pending check in the IRQ handler
` [PATCH v10 4/8] gpio: pl061: convert register access to regmap
` [PATCH v10 5/8] gpio: pl061: use IRQ_TYPE_LEVEL_MASK and IRQ_TYPE_EDGE_BOTH
` [PATCH v10 6/8] gpio: pl061: use cleanup helpers for locks
` [PATCH v10 7/8] gpio: pl061: switch data path to gpio-regmap
` [PATCH v10 8/8] gpio: pl061: add Ambarella register-layout variant
[PATCH] dt-bindings: cpufreq: qcom-nvmem: Allow generic OPP tables
2026-10-15 11:07 UTC (2+ messages)
[PATCH v2 0/8] Enable more nodes for the Xperia 10 III
2026-10-15 11:06 UTC (9+ messages)
` [PATCH v2 5/8] arm64: dts: qcom: sm6350-lena: Enable Bluetooth
` [PATCH v2 6/8] arm64: dts: qcom: sm6350-lena: Enable wifi
` [PATCH v2 7/8] arm64: dts: qcom: sm6350-lena: Enable PM7250B
` [PATCH v2 8/8] arm64: dts: qcom: sm6350-lena: Enable PMK8350
[PATCH v2 0/6] Add CCI and CAMSS support for Glymur
2026-10-15 11:02 UTC (8+ messages)
` [PATCH v2 1/6] arm64: dts: qcom: glymur: Add CAMSS and CSIPHY nodes "
` [PATCH v2 2/6] arm64: dts: qcom: glymur: Add CCI definitions "
` [PATCH v2 3/6] arm64: dts: qcom: glymur: Add camera MCLK pinctrl
` [PATCH v2 4/6] arm64: dts: qcom: glymur-crd: Add PM8010 camera PMIC
` [PATCH v2 5/6] arm64: dts: qcom: glymur-crd: Add ov08x40 RGB sensor on CSIPHY4
` [PATCH v2 6/6] arm64: defconfig: Enable OV08X40 camera sensor driver
[PATCH v2 0/7] mfd: qcom-pm8008: Add support for PM8010 over I2C
2026-10-15 11:00 UTC (3+ messages)
` [PATCH v2 7/7] mfd: qcom-pm8008: Tolerate missing interrupt
[RFC PATCH 00/16] Centralize the ownership of power rail votes for Qualcomm clocks
2026-10-15 10:57 UTC (2+ messages)
[PATCH 00/13] drm/msm/dcp: Add Qualcomm DCP display support
2026-10-15 10:52 UTC (5+ messages)
` [PATCH 01/13] dt-bindings: display: msm: Add Qualcomm DCP bindings
` [PATCH 13/13] arm64: dts: qcom: hawi: Add DCP support
[PATCH 0/2] irqchip/gic-v5: Fix standalone IRSes OF driver probe and DT bindings
2026-10-15 10:50 UTC (3+ messages)
` [PATCH 1/2] dt-bindings: interrupt-controller: gicv5: Relax IRS properties constraints
[PATCH v3 0/5] iio: pressure: dps310: add Zilltek ZTS8032
2026-10-15 10:49 UTC (6+ messages)
` [PATCH v3 1/5] dt-bindings: vendor-prefixes: Add ZillTek Technology
` [PATCH v3 2/5] dt-bindings: iio: pressure: infineon,dps310: Add Zilltek ZTS8032
` [PATCH v3 3/5] iio: pressure: dps310: add per-chip data
` [PATCH v3 4/5] iio: pressure: dps310: add an OF match table
` [PATCH v3 5/5] iio: pressure: dps310: add Zilltek ZTS8032 support
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox