messages from 2026-10-15 15:10:29 to 2026-10-15 17:55:21 UTC [more...]
[PATCH v6 0/4] arm64: amlogic: T7 thermal support
2026-10-15 17:54 UTC (5+ messages)
` [PATCH v6 1/4] arm64: dts: amlogic: t7: Add cooling cells to all CPUs
` [PATCH v6 2/4] arm64: dts: amlogic: t7: Add thermal sensor nodes
` [PATCH v6 3/4] arm64: dts: amlogic: t7: Add thermal zones
` [PATCH v6 4/4] arm64: dts: amlogic: t7: khadas-vim4: Add fan cooling to "
[PATCH v10 00/19] spi: cadence-quadspi: add PHY tuning support
2026-10-15 17:47 UTC (2+ messages)
[PATCH v2 0/2] PM: spacemit: Add power domain support
2026-10-15 17:38 UTC (7+ messages)
` [PATCH v2 1/2] dt-bindings: power: spacemit: Add power domain controller IDs
` [PATCH v2 2/2] pmdomain: spacemit: Add power domain driver
[PATCH v5 5/5] arm64: dts: qcom: qcs6490-rb3gen2: Enable TC9563 embedded GPIO controller
2026-10-15 17:26 UTC (2+ messages)
[PATCH v12 00/20] dmaengine: ti: Add support for BCDMA v2 and PKTDMA v2
2026-10-15 17:09 UTC (3+ messages)
` [PATCH v12 01/20] dmaengine: ti: k3-udma: Fix sporadic crash on AM62x
[PATCH v11 0/5] clocksource/timer-econet-en751221: Support irq number per timer
2026-10-15 17:07 UTC (9+ messages)
` [PATCH v11 1/5] dt-bindings: timer: econet: Update EN751627 for multi-IRQ
` [PATCH v11 2/5] clocksource/timer-econet-en751221: Init teardown on error if possible
` [PATCH v11 3/5] clocksource/timer-econet-en751221: Disable IRQ until cevt registered
` [PATCH v11 4/5] clocksource/timer-econet-en751221: Support EN751627 without percpu IRQ
` [PATCH v11 5/5] clocksource/timer-econet-en751221: Do not use NR_CPUS for resource array size
[PATCH 00/10] iio: frequency: ad9910: add IIO backend support
2026-10-15 17:04 UTC (14+ messages)
` [PATCH 01/10] iio: frequency: ad9910: powerdown fix
` [PATCH 02/10] iio: backend: add devm_iio_backend_get_optional()
` [PATCH 03/10] dt-bindings: iio: frequency: add adi,ad9910-axi-backend
` [PATCH 04/10] dt-bindings: iio: frequency: ad9910: add io-backends property
` [PATCH 05/10] iio: frequency: ad9910: move channel indexes into a shared header
` [PATCH 06/10] iio: frequency: ad9910: add axi backend driver
` [PATCH 07/10] iio: frequency: ad9910: support drctl control
` [PATCH 08/10] iio: frequency: ad9910: support iio backend
` [PATCH 09/10] iio: ABI: add integration_time for output channels
` [PATCH 10/10] docs: iio: ad9910: document DRCTL pin control
[PATCH v2 0/3] Add Loongson-2K0300 APB DMA mux support
2026-10-15 17:03 UTC (3+ messages)
` [PATCH v2 3/3] dmaengine: loongson: Add Loongson-2K0300 APB DMA mux driver
[PATCH 0/2] ASoC: Add driver for Iron Device MA5311
2026-10-15 17:03 UTC (8+ messages)
` [PATCH 1/2] ASoC: dt-bindings: Add "
` [PATCH 2/2] ASoC: codecs: Add driver for "
[PATCH v10 00/10] clk: nuvoton: ma35d1: Fix mux parenting and peripheral clock rates
2026-10-15 16:50 UTC (13+ messages)
` [PATCH v10 01/10] clk: nuvoton: ma35d1: Use clk_hw pointers as mux parents
` [PATCH v10 02/10] clk: nuvoton: ma35d1: Avoid possible error pointer dereferencing
` [PATCH v10 03/10] clk: nuvoton: ma35d1: Retrieve HXT/LXT from DT when possible
` [PATCH v10 04/10] clk: nuvoton: ma35d1: Reparent the gates correctly
` [PATCH v10 05/10] clk: nuvoton: ma35d1: Use device managed helpers for fixed rate clocks
` [PATCH v10 06/10] clk: Create devm_clk_hw_register_fixed_rate_parent_hw()
` [PATCH v10 07/10] clk: nuvoton: ma35d1: Reparent SYSPLL correctly
` [PATCH v10 08/10] MAINTAINERS: Add myself as Nuvoton MA35D1 clock controller
` [PATCH v10 09/10] arm64: dts: nuvoton: ma35d1: Drop HXT clock output name
` [PATCH v10 10/10] arm64: dts: nuvoton: ma35d1: Add LXT crystal and clock-names
[RFC PATCH v2 00/15] Arm Core Local Accelerator Driver
2026-10-15 16:44 UTC (8+ messages)
` [RFC PATCH v2 02/15] misc/arm-cla: Add launch operation helpers
` [RFC PATCH v2 12/15] vfio: Support VFIO devices that access the CPU MMU
` [RFC PATCH v2 15/15] misc/arm-cla: Add vfio-mdev user interface
[PATCH net-next v2 0/2] net: phy: qcom: add qca808x support
2026-10-15 16:37 UTC (7+ messages)
` [PATCH net-next v2 2/2] net: phy: qcom: qca808x: Add regulator management
[PATCH RFC 0/5] nvmem: Add a UEFI variable backed NVMEM provider
2026-10-15 16:27 UTC (2+ messages)
[PATCH v1 0/2] arm64: dts: freescale: Remove Toradex OSM Development Board ETH_A PHY interrupt
2026-10-15 16:26 UTC (5+ messages)
` [PATCH v1 1/2] arm64: dts: freescale: imx95-toradex-osm-dev: Remove "
[PATCH v1 1/1] arm64: dts: imx8mm-var-dart-sonata: Add OV5640 camera support
2026-10-15 16:23 UTC
[PATCH v2 0/5] LVDS support for TQMa8Xx
2026-10-15 16:22 UTC (4+ messages)
` [PATCH v2 2/5] arm64: dts: imx8qxp: Add display controller subsystem
[PATCH v4 00/16] Update imx678 to act as a common Sony Starvis 2 driver
2026-10-15 16:15 UTC (20+ messages)
` [PATCH v4 01/16] media: imx678: Rework into generic Starvis 2 sensor driver
` [PATCH v4 02/16] media: sony-starvis2: Reorder link frequencies to remove lookup
` [PATCH v4 03/16] media: sony-starvis2: Always program the sensor in window mode
` [PATCH v4 04/16] media: sony-starvis2: Parameterise the configuration to allow for other models
` [PATCH v4 05/16] media: sony-starvis2: Rework 2 lane support for higher link freqs
` [PATCH v4 06/16] media: sony-starvis2: Allow runtime control of link frequency
` [PATCH v4 07/16] media: sony-starvis2: Correct the exposure range
` [PATCH v4 08/16] media: sony-starvis2: Put module into standby after identify
` [PATCH v4 09/16] media: sony-starvis2: Use pm_runtime_autosuspend
` [PATCH v4 10/16] media: dt-bindings: sony,imx678: Add other Starvis 2 family members
` [PATCH v4 11/16] media: sony-starvis2: Add support for IMX662
` [PATCH v4 12/16] media: sony-starvis2: Add support for IMX675
` [PATCH v4 13/16] media: sony-starvis2: Add support for IMX832
` [PATCH v4 14/16] media: sony-starvis2: Only update bits for window mode
` [PATCH v4 15/16] media: sony-starvis2: Parameterise exposure min and step
` [PATCH v4 16/16] media: sony-starvis2: Add support for IMX585
[PATCH v4 1/2] dt-bindings: leds: lacie,netxbig-leds: Convert to DT schema
2026-10-15 15:53 UTC (2+ messages)
` (subset) "
[PATCH v10 0/5] clocksource/timer-econet-en751221: Support irq number per timer
2026-10-15 15:53 UTC (4+ messages)
` [PATCH v10 4/5] clocksource/timer-econet-en751221: Support EN751627 without percpu IRQ
[PATCH v5] dt-bindings: mfd: rockchip,rk805: Convert pinctrl to DT schema
2026-10-15 15:53 UTC (2+ messages)
` (subset) "
[PATCH v2 RESEND 0/3] ARM: dts: stm32: support secure watchdog on STM32MP1 platforms
2026-10-15 15:48 UTC (4+ messages)
` [PATCH v2 RESEND 1/3] ARM: dts: stm32: move ARM SMC watchdog to STM32MP151 SoC
` [PATCH v2 RESEND 2/3] ARM: dts: stm32: enable ARM SMC watchdog on ST STM32MP15 boards
` [PATCH v2 RESEND 3/3] ARM: stm32: enable arm-smc watchdog on STM32MP1
[PATCH v5 00/11] leds: pca995x: Minor fixes; reset, output-gain, error reporting and group brightness support
2026-10-15 15:47 UTC (3+ messages)
` [PATCH v5 09/11] leds: pca995x: Add sysfs files for error reporting
[PATCH v13 00/13] ZTE zx297520v3 clock bindings and driver
2026-10-15 15:34 UTC (3+ messages)
` [PATCH v13 04/13] mfd: zx297520v3: Add a clock and reset MFD driver
[PATCH 0/6] Add AMD PL Mailbox and RPMsg support for the AMD BRAM remoteproc
2026-10-15 15:31 UTC (5+ messages)
` [PATCH 3/6] dt-bindings: mailbox: Add AMD PL Mailbox IP
[PATCH v2 0/4] Add support for Talos Lyra EVK board
2026-10-15 15:26 UTC (4+ messages)
` [PATCH v2 3/4] arm64: dts: qcom: talos: Add "
Add initial support for Qualcomm SM7250 SoC
2026-10-15 15:19 UTC (7+ messages)
` [PATCH v10 2/6] clk: qcom: Add Global Clock Controller (GCC) driver for SM7250
` [PATCH v10 4/6] dt-bindings: interrupt-controller: qcom,pdc: Document SM7250 PDC
[PATCH v3 0/2] Add support for SA8255P in the phy-qcom-snps-femto-v2 phy driver
2026-10-15 15:15 UTC (3+ messages)
[PATCH v4 1/4] dt-bindings: mfd: qcom,spmi-pmic: add compatibles for pm4125-codec
2026-10-15 15:15 UTC (2+ messages)
` (subset) "
[PATCH v2] dt-bindings: power: Convert mediatek,mt2701-scpsys to DT schema
2026-10-15 15:10 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox