messages from 2026-10-28 21:57:30 to 2026-10-29 03:47:54 UTC [more...]
[PATCH RFC v3 0/3] arm64: dts: qcom: nord: Add display support
2026-10-29 3:47 UTC (3+ messages)
` [PATCH RFC v3 1/3] arm64: dts: qcom: nord: Add display subsystem nodes
` [PATCH RFC v3 2/3] arm64: dts: qcom: nord-ride-embedded: Enable eDP0-3 display output
[PATCH 0/6] Tegra264 GB10B boards the bus
2026-10-29 3:32 UTC (7+ messages)
` [PATCH 1/6] dt-bindings: PCI: tegra264: Allow the ats-supported property
` [PATCH 2/6] PCI/pwrctrl: Enable pwrctrl for devices powered by a power domain
` [PATCH 3/6] PCI/pwrctrl: Add the Tegra264 iGPU to the generic match table
` [PATCH 4/6] PCI: tegra264: Power endpoint devices before enumeration
` [PATCH 5/6] arm64: tegra: Add node for the GB10B GPU on Tegra264
` [PATCH 6/6] arm64: tegra: Enable and mark the Tegra264 GPU PCIe controller as ATS supported
[PATCH v1] arm64: dts: qcom: purwa-iot-evk: add missing DP2 audio link
2026-10-29 3:27 UTC (3+ messages)
[PATCH v7 0/5] Add support for S4 audio
2026-10-29 2:56 UTC (4+ messages)
` [PATCH v7 1/5] dt-bindings: clock: meson: Add audio power domain for S4 soc
[PATCH v1 0/2] ASoC: codecs: nau8310: Add NAU83G10 amplifier
2026-10-29 2:24 UTC (4+ messages)
` [PATCH v1 2/2] ASoC: codecs: nau8310: Add support for "
[PATCH 0/3] iio: proximity: Add Benewake TF-Luna LiDAR driver
2026-10-29 2:22 UTC (8+ messages)
` [PATCH 2/3] dt-bindings: iio: proximity: Add Benewake TF-Luna
` [PATCH 3/3] iio: proximity: Add Benewake TF-Luna LiDAR driver
[PATCH v4 0/5] Add UFS support for Glymur Qualcomm SoC
2026-10-29 2:02 UTC (2+ messages)
` (subset) "
[PATCH v3 0/7] net: dsa: mt7530: support EcoNet EN751221
2026-10-29 2:02 UTC (13+ messages)
` [PATCH v3 3/7] net: dsa: mediatek: add support for passthrough mode
` [PATCH v3 4/7] net: dsa: mediatek: support PLL setup on MMIO MT7530
` [PATCH v3 5/7] net: dsa: mediatek: support MDIO switch downstream of MMIO switch
` [PATCH v3 7/7] net: dsa: mediatek: support EN751221 switch
[PATCH v3 6/7] dt-bindings: net: dsa: mediatek,mt7530: add econet,en751221
2026-10-29 2:02 UTC (2+ messages)
[PATCH v3 2/7] dt-bindings: net: dsa: mediatek,mt7530: add passthrough mode
2026-10-29 2:02 UTC (2+ messages)
[PATCH v3 1/7] net: dsa: mt7530: get ctrl phy addr using a function
2026-10-29 2:02 UTC (2+ messages)
[PATCH v3 0/3] Use icc-clk for the SM8250 camera NoC AXI clock
2026-10-29 1:50 UTC (14+ messages)
` [PATCH v3 1/3] dt-bindings: clock: qcom,camcc-sm8250: add interconnect provider
` [PATCH v3 3/3] arm64: dts: qcom: sm8250: add camcc interconnect cells
[PATCH v9 0/2] ARM: dts: aspeed: Add ASRock Rack B650D4U BMC
2026-10-29 1:50 UTC (4+ messages)
` [PATCH v9 2/2] "
[PATCH 0/4] fdtfactor: Introduce fdtfactor to auto-factor overlays
2026-10-29 1:28 UTC (19+ messages)
` [PATCH 2/4] fdtfactor: Add tool to split DTBs into a base DTB and overlays
` [PATCH 3/4] fdtfactor: Support compressed DTB inputs and outputs
` [PATCH 4/4] fdtfactor: Add compiled FIT image factoring support
[PATCH v2 0/4] This series adds support for Texas Instruments OPT4041 Ambient light sensor
2026-10-29 0:06 UTC (4+ messages)
` [PATCH v2 1/4] dt-bindings: iio: light: opt4001: add opt4041
[PATCH] dt-bindings: Fix property name typos in if/then schemas
2026-10-28 23:46 UTC (2+ messages)
[PATCH v2] dt-bindings: remoteproc: ti,keystone-rproc: Convert to DT schema
2026-10-28 23:17 UTC
[PATCH v3 0/4] iio: adc: ltc2497: add LTC2493 support and line-frequency rejection
2026-10-28 22:24 UTC (5+ messages)
` [PATCH v3 1/4] dt-bindings: iio: adc: lltc,ltc2497: add LTC2493 support
` [PATCH v3 2/4] iio: adc: ltc2497: add FA/FB line-frequency rejection selection
` [PATCH v3 3/4] iio: adc: ltc2497: select the channel set per device
` [PATCH v3 4/4] iio: adc: ltc2497: add LTC2493 support
[RFC PATCH 00/23] ASoC: qcom: AudioReach Active speaker protection for WSA884x
2026-10-28 21:59 UTC (4+ messages)
` [RFC PATCH 22/23] arm64: dts: qcom: glymur-crd: add WSA speaker protection VI feedback
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox