messages from 2026-10-31 07:06:16 to 2026-10-31 11:52:51 UTC [more...]
[PATCH v23 00/15] media: qcom: camss: Add Kaanapali support
2026-10-31 11:52 UTC (9+ messages)
` [PATCH v23 01/15] dt-bindings: phy: qcom,x1e80100-csi2-phy: Add Kaanapali CSI2 PHY
` [PATCH v23 05/15] media: dt-bindings: Add CAMSS device for Kaanapali
` [PATCH v23 11/15] media: qcom: camss: tpg: Add support for v2.4.0 TPG
` [PATCH v23 12/15] arm64: dts: qcom: kaanapali: Add CAMSS and CSIPHY block definitions
[PATCH v7 0/4] phy: nuvoton: extend MA35D1 USB2 PHY driver for dual-port OTG support
2026-10-31 11:50 UTC (4+ messages)
` [PATCH v7 4/4] phy: nuvoton: phy-ma35d1-usb2: extend to dual-port with "
[PATCH 0/6] media: qcom: camss: Add SM8650 TPG support
2026-10-31 11:34 UTC (10+ messages)
` [PATCH 1/6] dt-bindings: media: qcom,sm8650-camss: Add test pattern generators
` [PATCH 2/6] media: qcom: camss: Skip TPG if its registers are not described
` [PATCH 3/6] media: qcom: camss: tpg: Add support for v2.4.0 TPG
` [PATCH 4/6] media: qcom: camss: tpg: Support TPG hardware version 2.2.0
` [PATCH 5/6] media: qcom: camss: Add SM8650 TPG support
` [PATCH 6/6] arm64: dts: qcom: sm8650: Add CAMSS test pattern generators
[PATCH RFC 00/12] Add BL808 UART3 support with a Rust serial-core polling console
2026-10-31 11:26 UTC (7+ messages)
` [PATCH RFC 12/12] MAINTAINERS: Add Bouffalo Lab BL808 support
[PATCH 0/3] phy: qcom: Describe the AHB2PHY bridge clock on Nord
2026-10-31 11:25 UTC (3+ messages)
` [PATCH 3/3] phy: phy-snps-eusb2: Enable AHB2PHY bus "
[PATCH v2 0/2] arm64: dts: rockchip: NanoPi R2S Plus: fix io-domains, enable SDIO Wi-Fi
2026-10-31 10:47 UTC (3+ messages)
` [PATCH v2 1/2] arm64: dts: rockchip: Fix VCCIO4/VCCIO6 supplies on NanoPi R2S Plus
` [PATCH v2 2/2] arm64: dts: rockchip: Enable SDIO Wi-Fi "
[PATCH 0/2] arm64: dts: rockchip: NanoPi R2S Plus: fix io-domains, enable SDIO Wi-Fi
2026-10-31 10:42 UTC (5+ messages)
` [PATCH 2/2] arm64: dts: rockchip: Enable SDIO Wi-Fi on NanoPi R2S Plus
[PATCH v4 0/2] i2c: Add Synopsys Advanced I2C (DWC_i2c) support for TI TDA54
2026-10-31 10:28 UTC (9+ messages)
` [PATCH v4 1/2] dt-bindings: i2c: Add Synopsys DWC_i2c controller
` [PATCH v4 2/2] i2c: Add Synopsys Advanced I2C (DWC_i2c) driver
[PATCH v2 1/2] dt-bindings: i2c: mt7621: Document an7581 compatible
2026-10-31 10:26 UTC (2+ messages)
` [PATCH v2 2/2] i2c: mt7621: limit SCL_STRETCH only to Mediatek SoC
[PATCH RFC v3 0/5] arm64: dts: qcom: nord: Add PCIe and WLAN/BT support
2026-10-31 10:20 UTC (3+ messages)
` [PATCH RFC v3 3/5] arm64: dts: qcom: nord-ride-embedded: Enable PCIe controllers and PHY
[PATCH v2 0/7] arm64: dts: qcom: Introduce SA8255P as Lemans family SoC
2026-10-31 9:06 UTC (11+ messages)
` [PATCH v2 4/7] arm64: dts: qcom: lemans: Add label for firmware and reserved-memory
` [PATCH v2 5/7] arm64: dts: qcom: Add device tree for Lemans GearVM variant
[PATCH] arm64: dts: st: fix arm,smc-id of the SMC watchdog on stm32mp2
2026-10-31 8:45 UTC (4+ messages)
[PATCH 0/2] iio: adc: add LTC2387 and ADAQ2387x support
2026-10-31 8:36 UTC (3+ messages)
[PATCH 0/5] drm/msm/dpu: Add SM7250 display support
2026-10-31 8:16 UTC (8+ messages)
` [PATCH 1/5] dt-bindings: display/msm: dsi-controller-main: Add SM7250
` [PATCH 2/5] dt-bindings: display/msm: dpu: Document SM7250
` [PATCH 3/5] dt-bindings: display/msm: Add SM7250 MDSS
` [PATCH 4/5] drm/msm/dpu: Add SM7250 support
` [PATCH 5/5] drm/msm: mdss: "
[PATCH v3 2/2] i2c: amlogic: Add Amlogic A9 I2C controller driver
2026-10-31 8:09 UTC (2+ messages)
[PATCH 0/6] thermal: Add hardware-binned trip point support
2026-10-31 7:24 UTC (8+ messages)
` [PATCH 4/6] thermal: qcom: tsens: add hardware-bin trip-point filtering
[PATCH v4 0/4] regulator: add the Will Semiconductor WL2868C camera PMIC
2026-10-31 7:10 UTC (5+ messages)
` [PATCH v4 3/4] arm64: dts: qcom: sm8750: describe two of the three CCI I2C controllers
` [PATCH v4 4/4] arm64: dts: qcom: sm8750-lenovo-elden: describe the WL2868C regulators
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox