messages from 2026-11-05 23:06:33 to 2026-11-06 04:11:56 UTC [more...]
[PATCH v9 0/3] Add support for the Sony IMX681 camera sensor
2026-11-06 4:11 UTC (4+ messages)
` [PATCH v9 1/3] dt-bindings: media: Add Sony IMX681
` [PATCH v9 2/3] media: i2c: Add Sony IMX681 sensor driver
` [PATCH v9 3/3] media: ipu-bridge: Add Sony IMX681
[PATCH v2 0/5] media: qcom: camss: Add SM8150 CAMSS support
2026-11-06 3:41 UTC (9+ messages)
` [PATCH v2 1/5] dt-bindings: i2c: qcom-cci: Document SM8150 compatible
` [PATCH v2 2/5] dt-bindings: media: qcom,sm8150-camss: Add SM8150 CAMSS
` [PATCH v2 3/5] media: qcom: camss: Match VFE lite clocks by name prefix
` [PATCH v2 4/5] media: qcom: camss: Add support for SM8150
` [PATCH v2 5/5] arm64: dts: qcom: sm8150: Add CAMSS and CCI nodes
[PATCH 0/2] spacemit: k3: Add support for BS01DCMA board
2026-11-06 3:39 UTC (5+ messages)
` [PATCH 2/2] riscv: dts: spacemit: Add K3 BS01DCMA support
[PATCH 0/7] Bluetooth: make the Amlogic W1 (W155S2) usable
2026-11-06 3:28 UTC (7+ messages)
` [PATCH 3/7] Bluetooth: hci_aml: cope with a controller that is already running
` [PATCH 5/7] Bluetooth: hci_aml: take the address from the firmware description
` [PATCH 7/7] Bluetooth: hci_aml: configure the RF for a shared antenna
[PATCH v5 0/7] Add ethernet support for the Amlogic T7
2026-11-06 3:16 UTC (4+ messages)
` [PATCH v5 2/7] dt-bindings: net: amlogic,meson-dwmac: add amlogic,t7-dwmac
[PATCH v3 0/3] arm64: dts: qcom: Add CSI2 PHY common-phy providers for SA8775P, QCS8300 and SC7280
2026-11-06 3:13 UTC (7+ messages)
` [PATCH v3 1/3] arm64: dts: qcom: lemans: add CSI2 D-PHY common-phy providers
` [PATCH v3 2/3] arm64: dts: qcom: monaco: add CSI2 PHY "
` [PATCH v3 3/3] arm64: dts: qcom: kodiak: add CSI2 D-PHY "
[PATCH 0/3] ARM: dts: aspeed: ventura2: Add LTC2305 ADCs and GPIO line names
2026-11-06 3:09 UTC (5+ messages)
` [PATCH 1/3] ARM: dts: aspeed: ventura2: Add LTC2305 ADCs
` [PATCH 2/3] ARM: dts: aspeed: ventura2: Name the COMe presence GPIO
` [PATCH 3/3] ARM: dts: aspeed: ventura2: Name the USB-UART bridge reset GPIOs
[PATCH 0/4] media: qcom: camss: Add SM8150 CAMSS support
2026-11-06 3:06 UTC (10+ messages)
` [PATCH 2/4] dt-bindings: media: qcom,sm8150-camss: Add SM8150 CAMSS
` [PATCH 3/4] media: qcom: camss: Add support for SM8150
[PATCH 0/2] iio: magnetometer: add Infineon TLE493D-W2B6 support
2026-11-06 3:04 UTC (5+ messages)
` [PATCH 1/2] dt-bindings: iio: magnetometer: add Infineon TLE493D-W2B6
` [PATCH 2/2] iio: magnetometer: add Infineon TLE493D-W2B6 driver
[PATCH v11 0/2] i2c: ls2x: Add clock- related properties and parsing
2026-11-06 3:02 UTC (3+ messages)
` [PATCH v11 1/2] dt-bindings: i2c: ls2x-i2c: Add clocks and clock-frequency properties
` [PATCH v11 2/2] i2c: ls2x: Add clocks property parsing and adjust bus speed
[PATCH v16 0/7] Provide support for Trigger Generation Unit
2026-11-06 2:59 UTC (4+ messages)
` [PATCH v16 2/7] qcom-tgu: Add TGU driver
[PATCH v4 05/16] clk: at91: Allow enabling main_rc_osc through DT
2026-11-06 2:39 UTC (2+ messages)
[PATCH v2 0/2] riscv: dts: sophgo: add cv1800b ethernet support overlay
2026-11-06 2:16 UTC (3+ messages)
` [PATCH v2 1/2] riscv: dts: sophgo: make sg2002-milkv-duo256m-eth overlay generic
[PATCH v8 0/6] of: teach overlay code to keep /aliases in sync
2026-11-06 2:11 UTC (3+ messages)
[PATCH 0/4] soc: toshiba: tc9564: config system controller
2026-11-06 1:50 UTC (3+ messages)
[PATCH 0/2] Input: add support for the FocalTech FT3683G touchscreen
2026-11-06 1:49 UTC (4+ messages)
` [PATCH 2/2] Input: add FocalTech FT3683G touchscreen driver
[PATCH v3 0/5] soc: cix: Add the Sky1 AUDSS DMA-350 interrupt path
2026-11-06 1:35 UTC (6+ messages)
` [PATCH v3 1/5] dt-bindings: soc: cix: Describe the Sky1 AUDSS DMA IRQ controller
` [PATCH v3 2/5] clk: cix: Handle Sky1 AUDSS DMA interrupt gates as an irqchip
` [PATCH v3 3/5] dt-bindings: dma: arm,dma-350: Document dma-channel-mask
` [PATCH v3 4/5] dmaengine: arm-dma350: Honour dma-channel-mask
` [PATCH v3 5/5] arm64: dts: cix: Add the Sky1 AUDSS DMA-350 integration
[PATCH v6 0/5] dmaengine: arm-dma350: Add slave support and Sky1 integration
2026-11-06 1:34 UTC (6+ messages)
` [PATCH v6 1/5] dmaengine: arm-dma350: Fix source trigger bit
` [PATCH v6 2/5] dmaengine: arm-dma350: Add slave and cyclic transfer support
` [PATCH v6 3/5] dt-bindings: dma: arm,dma-350: Describe the CIX Sky1 integration
` [PATCH v6 4/5] dmaengine: arm-dma350: Support integration clocks and resets
` [PATCH v6 5/5] arm64: dts: cix: Describe the Sky1 FCH DMA-350 integration
[PATCH 0/2] dmaengine: ma35d1-pdma: Add MA35D1 PDMA driver
2026-11-06 0:39 UTC (5+ messages)
` [PATCH 2/2] "
[PATCH 0/4] clk: Add the Siflower SF19A2890 clock manager and peripheral clock and reset managers
2026-11-06 0:34 UTC (4+ messages)
` [PATCH 3/4] dt-bindings: clock: Add Siflower SF19A2890 peripheral clock/reset managers
[PATCH net-next 0/2] net: stmmac: Add the Siflower SF19A2890 glue
2026-11-06 0:12 UTC (8+ messages)
` [PATCH net-next 1/2] dt-bindings: net: Add Siflower SF19A2890 GMAC
[PATCH v1 0/2] Add strprefix() and fix a bug with it
2026-11-06 0:01 UTC (13+ messages)
` [PATCH v1 1/2] string: Add strprefix(), and deprecate str_has_prefix()
[PATCH v8 00/11] Add Initial Support For MSM8952, Add General Mobile Shamrock
2026-11-05 23:54 UTC (3+ messages)
` [PATCH v8 03/11] dt-bindings: watchdog: qcom-wdt: Document MSM8952 watchdog
[PATCH v3 0/4] phy: qcom-mipi-csi2: Add D-PHY support for sa8775p, qcs8300 and sc7280
2026-11-05 23:51 UTC (5+ messages)
` [PATCH v3 1/4] dt-bindings: phy: qcom: Add common qcom,csi2-phy
` [PATCH v3 2/4] phy: qcom-mipi-csi2: Make OPP table optional
` [PATCH v3 3/4] phy: qcom-mipi-csi2: Add sa8775p D-PHY support
` [PATCH v3 4/4] phy: qcom-mipi-csi2: Add sc7280 D-PHY provider
[PATCH net-next 0/2] net: mctp: Add MCTP transport for the Axiado AX3005 IRoT
2026-11-05 23:40 UTC (2+ messages)
[PATCH v2 0/7] BCMBCA PMB clock, reset and hardware monitoring support
2026-11-05 23:06 UTC (4+ messages)
` [PATCH v2 5/7] clk: bcm: Add BCMBCA PMB clocks
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox