messages from 2026-11-13 08:07:58 to 2026-11-13 08:16:42 UTC [more...]
[PATCH 0/4] Wire up LCDB regulator on Fairphone 3 & Fairphone 4
2026-11-13 8:16 UTC (5+ messages)
` [PATCH 1/4] arm64: defconfig: Enable Qualcomm LCDB regulator
` [PATCH 2/4] arm64: dts: qcom: sdm632-fairphone-fp3: Wire up PMI632 LCDB
` [PATCH 3/4] arm64: dts: qcom: pm6150l: add LCDB regulators
` [PATCH 4/4] arm64: dts: qcom: sm7225-fairphone-fp4: Wire up PM6150L LCDB
[PATCH v3 0/2] usb: dwc3: qcom: Keep USB 2.0 working in DisplayPort-only modes
2026-11-13 8:16 UTC (5+ messages)
` [PATCH v3 1/2] dt-bindings: usb: qcom,snps-dwc3: Add mode-switch
` [PATCH v3 2/2] usb: dwc3: qcom: Use the UTMI clock as PIPE clock in DisplayPort-only modes
[PATCH 0/3] pinctrl: ingenic: Add X2600 support
2026-11-13 8:14 UTC (4+ messages)
` [PATCH 1/3] dt-bindings: "
` [PATCH 2/3] pinctrl: ingenic: Add X2600 register and GPIO IRQ support
` [PATCH 3/3] pinctrl: ingenic: Add X2600 pin groups and functions
[PATCH v2 0/7] pinctrl: airoha: add AN7589 support
2026-11-13 8:14 UTC (5+ messages)
` [PATCH v2 3/7] pinctrl: airoha: make the chip SCU optional
` [PATCH v2 7/7] pinctrl: airoha: add support of an7589 SoC
[PATCH 0/2] soc: qcom: Add SoC ID for SM7550
2026-11-13 8:13 UTC (4+ messages)
` [PATCH 1/2] dt-bindings: arm: qcom,ids: "
[PATCH 0/2] soc: qcom: Add the SXR2250P SoC ID
2026-11-13 8:10 UTC (3+ messages)
` [PATCH 1/2] dt-bindings: arm: qcom,ids: Add SoC ID for SXR2250P
[PATCH 0/2] arm64: dts: qcom: sm7125-samsung: add grip sensor
2026-11-13 8:09 UTC (3+ messages)
` [PATCH 1/2] arm64: dts: qcom: sm7125-samsung: drop unused label
[PATCH 0/2] spacemit: k3: Add support for BS01DCMA board
2026-11-13 8:07 UTC (7+ messages)
` [PATCH 2/2] riscv: dts: spacemit: Add K3 BS01DCMA support
[PATCH 0/2] nvmem: Add byte-mask support for non-contiguous byte selection
2026-11-13 8:07 UTC (3+ messages)
` [PATCH 2/2] nvmem: core: add byte-mask support for non-contiguous cell bytes
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox