Re: [PATCH v2 1/1] gpio: omap: dts: Move interrupt-controller from #interrupt-cells description

[Javier Martinez Canillas <martinez.javier@gmail.com>]

On Mon, Mar 4, 2013 at 9:56 PM, Javier Martinez Canillas
<javier.martinez@collabora.co.uk> wrote:
> The binding documentation for the OMAP GPIO controller has the description
> for the "#interrupt-cells" property after the "interrupt-controller".
> This is confusing so is better to move the "interrupt-controller" after
> "#interrupt-cells" description.
>
> While being there, change the properties order to be consistent with
> Documentation/devicetree/bindings/interrupt-controller/interrupts.txt and
> Documentation/devicetree/bindings/gpio/gpio.txt.
>
> Reported-by: Stephen Warren <swarren@nvidia.com>
> Signed-off-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk>
> Acked-by: Jon Hunter <jon-hunter@ti.com>
> ---
>
> Changes since v1:
>   - Change the properties order to be consistent with the rest of the
>     DT bindings docs suggested by Jon Hunter.
>
>  .../devicetree/bindings/gpio/gpio-omap.txt         |    8 ++++----
>  1 files changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
> index bff51a2..a56e3a5 100644
> --- a/Documentation/devicetree/bindings/gpio/gpio-omap.txt
> +++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
> @@ -5,12 +5,12 @@ Required properties:
>    - "ti,omap2-gpio" for OMAP2 controllers
>    - "ti,omap3-gpio" for OMAP3 controllers
>    - "ti,omap4-gpio" for OMAP4 controllers
> +- gpio-controller : Marks the device node as a GPIO controller.
>  - #gpio-cells : Should be two.
>    - first cell is the pin number
>    - second cell is used to specify optional parameters (unused)
> -- gpio-controller : Marks the device node as a GPIO controller.
> +- interrupt-controller: Mark the device node as an interrupt controller.
>  - #interrupt-cells : Should be 2.
> -- interrupt-controller: Mark the device node as an interrupt controller
>    The first cell is the GPIO number.
>    The second cell is used to specify flags:
>      bits[3:0] trigger type and level flags:
> @@ -29,8 +29,8 @@ Example:
>  gpio4: gpio4 {
>      compatible = "ti,omap4-gpio";
>      ti,hwmods = "gpio4";
> -    #gpio-cells = <2>;
>      gpio-controller;
> -    #interrupt-cells = <2>;
> +    #gpio-cells = <2>;
>      interrupt-controller;
> +    #interrupt-cells = <2>;
>  };
> --
> 1.7.7.6
>

Hello,

Any comments on this patch?

I know is just a trivial documentation fix but I think it can be quite
helpful for people referring to gpio-omap binding.

Best regards,
Javier