Re: [PATCH v3 0/3] ARM/dts: omap3: Add DT support for IGEP devices

[Javier Martinez Canillas <martinez.javier@gmail.com>]

On Mon, Dec 3, 2012 at 1:41 PM, Javier Martinez Canillas
<javier.martinez@collabora.co.uk> wrote:
> IGEP technology devices are TI OMAP3 SoC based industrial embedded
> and computer-on-module boards. This patch-set adds initial device
> tree support for these devices.
>
> The device trees allows to boot from an MMC and are working all the
> components that already have device tree support on OMAP3 SoCs:
>
> - MMC/SD
> - UARTs
> - GPIO LEDs
> - TWL4030 codec audio
> - pinmux/pinconf pinctrl
>
> Some peripheral are still not working such as Flash storage and
> Ethernet but support for these will also be included once the
> OMAP GPMC device tree binding patches land on mainline.
>
> This is a v3 of the patch-set that solves issues pointed out by
> Enric Balletbo and Benoit Cousson.
>
> The patch-set is composed of the following patches:
>
> [PATCH v3 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices
> [PATCH v3 2/3] ARM/dts: omap3: Add support for IGEPv2 board
> [PATCH v3 3/3] ARM/dts: omap3: Add support for IGEP COM Module
>
> Best regards,
> Javier
> --

Hi Benoit and Tony,

Any comments on these?

Best regards,
Javier