Re: [PATCH] arm: dts: Add uart1 and uart2 to igep boards.

[Matthias Brugger <matthias.bgg@gmail.com>]

Hi Benoit,

2012/12/12 Benoit Cousson <b-cousson@ti.com>:
> Hi Matthias,
>
> On 12/12/2012 04:33 PM, Matthias Brugger wrote:
>> This patch is a follow-up patch for Javier Martinez effort adding initial
>> device tree support to IGEP technology devices. [1]
>>
>> It adds uart1 and uart2 bindings to the generic dtsi for the IGEP boards.
>>
>> [1] http://www.spinics.net/lists/linux-omap/msg83409.html
>>
>> Signed-off-by: Matthias Brugger <matthias.bgg@gmail.com>
>> ---
>>  arch/arm/boot/dts/omap3-igep.dtsi |   24 ++++++++++++++++++++++++
>>  1 file changed, 24 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/omap3-igep.dtsi b/arch/arm/boot/dts/omap3-igep.dtsi
>> index 125fe00..c02e3c0 100644
>> --- a/arch/arm/boot/dts/omap3-igep.dtsi
>> +++ b/arch/arm/boot/dts/omap3-igep.dtsi
>> @@ -27,6 +27,20 @@
>>  };
>>
>>  &omap3_pmx_core {
>> +     uart1_pins: pinmux_uart1_pins {
>> +             pinctrl-single,pins = <
>> +                     0x152 0x100     /* uart1_rx.uart1_rx INPUT | MODE0 */
>> +                     0x14c 0         /* uart1_tx.uart1_tx OUTPUT | MODE0 */
>> +             >;
>> +     };
>> +
>> +     uart2_pins: pinmux_uart2_pins {
>> +             pinctrl-single,pins = <
>> +                     0x14a 0x100     /* uart2_rx.uart2_rx INPUT | MODE0 */
>> +                     0x148 0         /* uart2_tx.uart2_tx OUTPUT | MODE0 */
>> +             >;
>> +     };
>> +
>>       uart3_pins: pinmux_uart3_pins {
>>               pinctrl-single,pins = <
>>                       0x16e 0x100     /* uart3_rx.uart3_rx INPUT | MODE0 */
>> @@ -77,6 +91,16 @@
>>       status = "disabled";
>>  };
>>
>> +&uart1 {
>> +       pinctrl-names = "default";
>> +       pinctrl-0 = <&uart1_pins>;
>> +};
>> +
>> +&uart2 {
>> +       pinctrl-names = "default";
>> +       pinctrl-0 = <&uart2_pins>;
>> +};
>> +
>>  &uart3 {
>>         pinctrl-names = "default";
>>         pinctrl-0 = <&uart3_pins>;
>>
>
> That looks good to me. I'll apply it on top of javier's series for 3.9.

Can you pin-point me to the repository where this patches are in right
now? I tried to figure it out these days, but didn't found where to
clone the repository from.

Thanks,
Matthias

>
> Thanks,
> Benoit
>



-- 
---
motzblog.wordpress.com