From: Linus Walleij <linus.walleij@linaro.org>
To: Brian Masney <masneyb@onstation.org>, Andy Gross <andy.gross@linaro.org>
Cc: Stephen Boyd <sboyd@kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
Marc Zyngier <marc.zyngier@arm.com>,
Shawn Guo <shawnguo@kernel.org>,
Doug Anderson <dianders@chromium.org>,
"open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>,
Nicolas Dechesne <nicolas.dechesne@linaro.org>,
Niklas Cassel <niklas.cassel@linaro.org>,
David Brown <david.brown@linaro.org>,
Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
"thierry.reding@gmail.com" <thierry.reding@gmail.com>,
linux-arm-msm@vger.kernel.org,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS"
<devicetree@vger.kernel.org>
Subject: Re: [PATCH v4 00/14] qcom: spmi: add support for hierarchical IRQ chip
Date: Mon, 14 Jan 2019 09:45:46 +0100 [thread overview]
Message-ID: <CACRpkdYFCid1Hr1auSezwo83Djm9C82L7WF4LzfW1a8gKLLsaQ@mail.gmail.com> (raw)
In-Reply-To: <CACRpkdbyiPwE8+onB0_Yu0i+6LZCFy8Z7MWWY7p-fjsb0JFVhw@mail.gmail.com>
On Mon, Jan 14, 2019 at 9:43 AM Linus Walleij <linus.walleij@linaro.org> wrote:
> Regarding the device trees, I think we usually merge device tree
> changes in parallel (orthogonally) and as long as the end result
> after merging both driver code and device tree changes is correct
> we do not bother *too* much about any intermittent states.
>
> That said I can of course merge the DTS changes in the pin control
> tree if I get some ACK from the Qualcomm maintainers.
>
> Else I will just apply patches 1-7 to the pin control tree ASAP and
> the DTS changes need to go through qcom (Andy's tree) and
> ARM SoC.
PS that would mean dropping patches 6 and 14 obviously.
If I merge all patches, I can keep them around.
Yours,
Linus Walleij
prev parent reply other threads:[~2019-01-14 8:45 UTC|newest]
Thread overview: 39+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-01-13 15:47 [PATCH v4 00/14] qcom: spmi: add support for hierarchical IRQ chip Brian Masney
2019-01-13 15:47 ` [PATCH v4 01/14] dt-bindings: pinctrl: qcom-pmic-gpio: add qcom,pmi8998-gpio binding Brian Masney
2019-01-14 23:42 ` Stephen Boyd
2019-01-15 0:28 ` Bjorn Andersson
2019-01-15 20:07 ` Rob Herring
2019-01-13 15:47 ` [PATCH v4 02/14] pinctrl: qcom: spmi-gpio: add support for three new variants Brian Masney
2019-01-14 23:43 ` Stephen Boyd
2019-01-15 0:28 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 03/14] pinctrl: qcom: spmi-gpio: hardcode IRQ counts Brian Masney
2019-01-14 23:43 ` Stephen Boyd
2019-01-15 0:34 ` Bjorn Andersson
2019-01-15 1:14 ` Brian Masney
2019-01-15 1:24 ` Brian Masney
2019-01-13 15:47 ` [PATCH v4 04/14] spmi: pmic-arb: convert to v2 irq interfaces to support hierarchical IRQ chips Brian Masney
2019-01-13 15:47 ` [PATCH v4 05/14] gpio: add irq domain activate/deactivate functions Brian Masney
2019-01-13 15:47 ` [PATCH v4 06/14] spmi: pmic-arb: disassociate old virq if hwirq mapping already exists Brian Masney
2019-01-14 23:50 ` Stephen Boyd
2019-01-15 0:42 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 07/14] qcom: spmi-gpio: add support for hierarchical IRQ chip Brian Masney
2019-01-13 15:47 ` [PATCH v4 08/14] ARM: dts: qcom: pm8941: add interrupt controller properties Brian Masney
2019-01-15 0:42 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 09/14] ARM: dts: qcom: pma8084: " Brian Masney
2019-01-14 23:44 ` Stephen Boyd
2019-01-15 0:42 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 10/14] arm64: dts: qcom: pm8005: " Brian Masney
2019-01-14 23:44 ` Stephen Boyd
2019-01-15 0:43 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 11/14] arm64: dts: qcom: pm8998: " Brian Masney
2019-01-14 23:44 ` Stephen Boyd
2019-01-15 0:43 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 12/14] arm64: dts: qcom: pmi8994: " Brian Masney
2019-01-14 23:43 ` Stephen Boyd
2019-01-15 0:43 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 13/14] arm64: dts: qcom: pmi8998: " Brian Masney
2019-01-14 23:43 ` Stephen Boyd
2019-01-15 0:43 ` Bjorn Andersson
2019-01-13 15:47 ` [PATCH v4 14/14] spmi: pmic-arb: revert "disassociate old virq if hwirq mapping already exists" Brian Masney
2019-01-14 8:43 ` [PATCH v4 00/14] qcom: spmi: add support for hierarchical IRQ chip Linus Walleij
2019-01-14 8:45 ` Linus Walleij [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=CACRpkdYFCid1Hr1auSezwo83Djm9C82L7WF4LzfW1a8gKLLsaQ@mail.gmail.com \
--to=linus.walleij@linaro.org \
--cc=andy.gross@linaro.org \
--cc=bjorn.andersson@linaro.org \
--cc=david.brown@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=dianders@chromium.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=marc.zyngier@arm.com \
--cc=mark.rutland@arm.com \
--cc=masneyb@onstation.org \
--cc=nicolas.dechesne@linaro.org \
--cc=niklas.cassel@linaro.org \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=shawnguo@kernel.org \
--cc=thierry.reding@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).