Re: [PATCH v2 0/4] Meson8m2 (32-bit ARM) SoC support

[Martin Blumenstingl <martin.blumenstingl@googlemail.com>]

On Fri, May 11, 2018 at 2:33 AM, Kevin Hilman <khilman@baylibre.com> wrote:
> Martin Blumenstingl <martin.blumenstingl@googlemail.com> writes:
>
>> This series adds support for the Meson8m2 SoC. This SoC is mostly
>> compatible with Meson8 while using some peripherals from Meson8b. Patch
>> #4 contains a list of (known) differences between the Meson8 and Meson8m2
>> SoCs.
>>
>> The first supported board with Meson8m2 SoC is the "Tronsmart MXIII Plus"
>> where Oleg contributed the initial .dts and heavily tested it (many
>> thanks!). His testing also confirmed that the Meson8m2 SoC uses the same
>> register layout for the Ethernet "glue registers (supported by the
>> dwmac-meson8b driver) as Meson8b.
>>
>> changes since v1 at [0]:
>> - do not create a new MACH_MESON8M2 Kconfig entry as suggested by Kevin
>>   (MACH_MESON8 is re-used instead). This affects patch #1 (which was
>>   patch #3 in v1) and patch #4 (which was patch #6 in v1)
>> - dropped patches #1 and #2 from v1 because Kevin already applied these
>>   ("dt-bindings: arm: amlogic: add support for the Meson8m2 SoC" and
>>   "dt-bindings: arm: amlogic: add support for the Tronsmart MXIII Plus")
>
> Applied to v4.18/dt.
thank you!

> One more request: Could you send one more patch (on top of my v4.18/dt)
> that gets rid of the Kconfig for the 8B also?
I put that on my TODO-list, I'll send a patch before my next batch of
32-bit dt updates


Regards
Martin