Re: [PATCH 6/8] riscv: dts: spacemit: Enable PDMA0 controller on Banana Pi F3

[Guodong Xu <guodong@riscstar.com>]

On Wed, Jun 11, 2025 at 9:58 PM Yixun Lan <dlan@gentoo.org> wrote:
>
> Hi Guodong,
>
> On 20:57 Wed 11 Jun     , Guodong Xu wrote:
> > Enable the Peripheral DMA controller (PDMA0) on the SpacemiT K1-based
> > Banana Pi F3 board by setting its status to "okay". This board-specific
> > configuration activates the PDMA controller defined in the SoC's base
> > device tree.
> >
>   Although this series is actively developed under Bananapi-f3 board
> but it should work fine with jupiter board, so I'd suggest to enable
> it too, thanks
>

I'd be glad to include the Jupiter board as well. Since I don't have Jupiter
hardware for testing, could someone with access verify it works before I
add it to the series?

-Guodong

> > Signed-off-by: Guodong Xu <guodong@riscstar.com>
> > ---
> >  arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts | 4 ++++
> >  1 file changed, 4 insertions(+)
> >
> > diff --git a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > index 2363f0e65724..115222c065ab 100644
> > --- a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > +++ b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > @@ -45,3 +45,7 @@ &uart0 {
> >       pinctrl-0 = <&uart0_2_cfg>;
> >       status = "okay";
> >  };
> > +
> > +&pdma0 {
> > +     status = "okay";
> > +};
> > --
> > 2.43.0
> >
> >
>
> --
> Yixun Lan (dlan)