Re: [PATCH v3 5/6] i2c: Add Actions Semiconductor Owl family S900 I2C driver

[Andy Shevchenko <andy.shevchenko@gmail.com>]

On Sat, Jun 30, 2018 at 4:33 PM, Manivannan Sadhasivam
<manivannan.sadhasivam@linaro.org> wrote:
> Add Actions Semiconductor Owl family S900 I2C driver.

Thanks for an update. Few left comments and it would LGTM.

> +static int owl_i2c_reset(struct owl_i2c_dev *i2c_dev)
> +{

> +       mdelay(1);

But now, since it's not used in atomic context, we may switch to
usleep_range() / msleep() instead.

> +       owl_i2c_update_reg(i2c_dev->base + OWL_I2C_REG_CTL,
> +                               OWL_I2C_CTL_EN, true);
> +

> +       /* Wait 50ms for FIFO reset complete */
> +       do {

> +               mdelay(1);

Especially in this case it's very important.

> +       } while (timeout++ < OWL_I2C_MAX_RETRIES);

> +}

> +       val = (i2c_dev->clk_rate + i2c_dev->bus_freq * 16 - 1) /
> +                               (i2c_dev->bus_freq * 16);

This is effectively DIV_ROUND_UP(->clk_rate, ->bus_freq * 16).

> +       /*
> +        * By default, 0 will be returned if interrupt occurred but no
> +        * read or write happened. Else if msg_ptr equals to message length,
> +        * message count will be returned.
> +        */

> +       if (i2c_dev->msg_ptr == msg->len)
> +               ret = num;

I dunno if

ret = ->msg_ptr == len ? num : 0;

would be slightly more explicit (yes, I aware about ret == 0).

Up to you to choose.

> +       /* We support only frequencies of 100k and 400k for now */
> +       if (i2c_dev->bus_freq != OWL_I2C_DEF_SPEED_HZ &&
> +                       i2c_dev->bus_freq > OWL_I2C_MAX_SPEED_HZ) {

I think it should be != in the second case as well.

> +               dev_err(dev, "invalid clock-frequency %d\n", i2c_dev->bus_freq);
> +               return -EINVAL;
> +       }

-- 
With Best Regards,
Andy Shevchenko