Re: [RFC PATCH] dt-binding: net: sfp binding documentation

[Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>]

On Mon, Aug 21, 2017 at 10:06 AM, Baruch Siach <baruch-NswTu9S1W3P6gbPvEgmw2w@public.gmane.org> wrote:
> Hi Russell,
>
> On Mon, Aug 21, 2017 at 01:53:17PM +0100, Russell King - ARM Linux wrote:
>> On Sun, Aug 20, 2017 at 01:28:06PM +0300, Baruch Siach wrote:
>> > Add device-tree binding documentation SFP transceivers. Support for SFP
>> > transceivers has been recently introduced (drivers/net/phy/sfp.c).
>> >
>> > Signed-off-by: Baruch Siach <baruch-NswTu9S1W3P6gbPvEgmw2w@public.gmane.org>
>> > ---
>> >
>> > The SFP driver is on net-next.
>> >
>> > Not sure about the rate-select-gpio property name. The SFP+ standard
>> > (not supported yet) uses two signals, RS0 and RS1. RS0 is compatible
>> > with the SFP rate select signal, while RS1 controls the Tx rate.
>>
>> SFP+ is usable with this, but the platforms I have do not wire the
>> rate select pins on the SFP+ sockets to GPIOs, but hard-wire them.
>
> So maybe naming this signal 'rate-select0-gpio' would make it more future
> (SPF+) proof? Or 'rate-select-rx-gpio'?

Just extend it by making it an array of 2 gpios.

Rob
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html